Go Back   Infamous Nissan - Hardbody / Frontier Forums > Tech Area > Wiring and Electrical

Thread Tools Display Modes
Old 11-18-2019, 01:54 AM   #11
Join Date: Jan 2015
Location: Edgeoftown
Posts: 54
Vehicle: Hardbody 1989
Thanks: 0
Thanked 1 Time in 1 Post

I tried as you suggested. I'm not sure I did it right though. I undid the clamp screw and was able to raise the distributor about an inch as I turned it seemingly to effect such that it would ride over a tooth to the next groove and then slip back down, but when I checked the timing, I could not get it to go far enough again. I tried to do two teeth, but with the same results. Am I not doing it right or something?
kenmack is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 04:37 PM.

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.