Go Back   Infamous Nissan - Hardbody / Frontier Forums > Tech Area > Wiring and Electrical

Reply
 
Thread Tools Display Modes
Old 11-18-2019, 01:54 AM   #11
kenmack
 
Join Date: Jan 2015
Location: Edgeoftown
Posts: 54
Vehicle: Hardbody 1989
Thanks: 0
Thanked 1 Time in 1 Post
Default

I tried as you suggested. I'm not sure I did it right though. I undid the clamp screw and was able to raise the distributor about an inch as I turned it seemingly to effect such that it would ride over a tooth to the next groove and then slip back down, but when I checked the timing, I could not get it to go far enough again. I tried to do two teeth, but with the same results. Am I not doing it right or something?
kenmack is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:51 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.