View Single Post
Old 12-30-2020, 12:42 AM   #5
kenmack
 
Join Date: Jan 2015
Location: Edgeoftown
Posts: 54
Vehicle: Hardbody 1989
Thanks: 0
Thanked 1 Time in 1 Post
Default

I got a nut at Autozone and some washers too. It's hard to tell from the parts diagram just what exactly is the shape of the spacer. I saw two conflicting images during my search. I put a washer where the spacer was supposed to be but when I installed the pulley, it would not turn freely. It seemed to be rubbing the pulley bracket so I put a washer between it and the next piece (11932). Everything turned fine then and when the old, cut belt was laid in all three pulleys, it looked to be straight. I suppose I'll run with it like this unless anyone sees a fault.
kenmack is offline   Reply With Quote
Thanked by:
rbourgeo (12-30-2020)