View Single Post
Old 01-29-2017, 10:00 PM   #4
harper
 
harper's Avatar
 
Join Date: Feb 2012
Location: Cali
Posts: 265
Vehicle: 04 Frontier
Thanks: 36
Thanked 48 Times in 45 Posts
Default

Belltech nitro 2 slammers (I think is the name) for the front. I have these on my frontier, the stocks were so worn it felt like I was in a boat. With the slammers it feels a little stiffer than stock but not by much.

The pinto shocks in the link above wear out pretty fast from what I've read, but I don't have experience with them so YMMV.

With blocks you don't need shorter shocks for the rear, since you're effectively just spacing the axle up from the mounting point of the rear shocks. I ran some "load leveler" shocks that pretty much just lifted the rear end up an inch which just prevents the rear from sagging after loading the bed up. If I were to do it again I'd just run air shocks in the back.
harper is offline   Reply With Quote