Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 129
Search took 0.01 seconds.
Search: Posts Made By: KivPanther
Forum: Engine and Drivetrain 06-12-2021, 06:56 PM
Replies: 25
Views: 551
Posted By KivPanther
So, update. The stumble hasn't gone away. In...

So, update. The stumble hasn't gone away. In fact, it's pretty noticable now.


The fuel pump, all injectors, pressure regulator, fuel filter, fuel lines, air filter, all six spark plugs, spark...
Forum: General Discussion 05-26-2021, 05:19 PM
Replies: 1,172
Views: 78,942
Posted By KivPanther
I’ve got an old Marlin .22 bolt action. DL-81 I...

I’ve got an old Marlin .22 bolt action. DL-81 I think? No serial. Old as dirt and no idea where it came from. Yard sale for $5.
Forum: Project Build Log 05-17-2021, 06:41 PM
Replies: 24
Views: 1,005
Posted By KivPanther
New cat and cat-back exhaust system since I'm...

New cat and cat-back exhaust system since I'm pretty sure that stock cat got cooked.
Forum: General Discussion 05-13-2021, 02:03 AM
Replies: 1,172
Views: 78,942
Posted By KivPanther
Haven’t seen a primer in nigh on a year. It’s...

Haven’t seen a primer in nigh on a year. It’s dark times, stranger.
Forum: Project Build Log 05-05-2021, 04:05 PM
Replies: 24
Views: 1,005
Posted By KivPanther
Pulled the bed and replaced my stock fuel pump...

Pulled the bed and replaced my stock fuel pump and all the rubber fuel hoses since it was sounding a bit anemic. Definitely an improvement, but that little stumble is still there under power. Now I...
Forum: Im Looking For . . . 04-20-2021, 02:04 PM
Replies: 13
Views: 367
Posted By KivPanther
Already got a set, but I appreciate it.

Already got a set, but I appreciate it.
Forum: Project Build Log 04-12-2021, 12:16 AM
Replies: 24
Views: 1,005
Posted By KivPanther
All new brakes, front and rear! Stops like a...

All new brakes, front and rear! Stops like a champ now and doesn't pull hard left under heavy braking. I did manage to lock up the rear brakes while bedding them in though, which leads me to wonder...
Forum: Hardbody Forum (D21) 04-12-2021, 12:15 AM
Replies: 23,111
Views: 1,696,823
Posted By KivPanther
Replaced both front brake rotors and pads,...

Replaced both front brake rotors and pads, replaced master cylinder, and flushed clutch fluid. I don't think brake fluid is supposed to look like this and I'm pretty sure the clutch master cylinder...
Forum: Hardbody Forum (D21) 04-07-2021, 06:04 PM
Replies: 7
Views: 181
Posted By KivPanther
I have ursine paws for hands and this particular...

I have ursine paws for hands and this particular cup holder does not interfere with shifting for me.
Forum: Hardbody Forum (D21) 04-07-2021, 02:52 PM
Replies: 23,111
Views: 1,696,823
Posted By KivPanther
Get you some spray adhesive. It's designed for...

Get you some spray adhesive. It's designed for that kind of work.
Forum: Hardbody Forum (D21) 04-06-2021, 08:43 PM
Replies: 7
Views: 181
Posted By KivPanther
The designer mentions that it may not fit right...

The designer mentions that it may not fit right on the older trucks. Guess that proves it.





That's Sarafina. A 2009 Suzuki V-Strom DL1000.
Forum: General Discussion 04-06-2021, 08:38 PM
Replies: 24
Views: 490
Posted By KivPanther
I carry a Streamlight ProTac HL-X. It's bright as...

I carry a Streamlight ProTac HL-X. It's bright as heck, durable, and lasts a long while on a rechargeable 18650 cell. It can also use two CR123s if you hate money.
Forum: Hardbody Forum (D21) 04-06-2021, 06:38 PM
Replies: 7
Views: 181
Posted By KivPanther
Cup holder!

For those of you with access to a 3D Printer, I came across this design on Thingiverse:


https://www.thingiverse.com/thing:2304131


I printed this one out of black PLA and I gotta say, it...
Forum: Engine and Drivetrain 04-05-2021, 02:03 AM
Replies: 25
Views: 551
Posted By KivPanther
On a hunch I removed and thoroughly cleaned the...

On a hunch I removed and thoroughly cleaned the Mass Airflow Sensor. The stumble is just barely noticeable now. Still hunting down the final cause, but it's looking like whatever it is was being...
Forum: Engine and Drivetrain 03-09-2021, 11:21 PM
Replies: 25
Views: 551
Posted By KivPanther
Started out fine but stumble returned on the...

Started out fine but stumble returned on the highway. It is still much more muted than before, but I’m back to square one.
Forum: Engine and Drivetrain 03-09-2021, 07:02 PM
Replies: 25
Views: 551
Posted By KivPanther
No dead spot, but the wide open throttle position...

No dead spot, but the wide open throttle position sensor wasn't working so I went ahead and replaced the TPS anyway. Haven't had a chance to test it under cruise yet but it does seem that the...
Forum: Project Build Log 03-09-2021, 05:43 PM
Replies: 24
Views: 1,005
Posted By KivPanther
I just might, but at least she'll be well cared...

I just might, but at least she'll be well cared for in her golden years unlike whoever had her before me!
Forum: Project Build Log 03-08-2021, 08:52 PM
Replies: 24
Views: 1,005
Posted By KivPanther
The Falcon has all new exhaust manifolds, which...

The Falcon has all new exhaust manifolds, which also means the ground straps have a more solid connection now. Dunno if that was causing issues but nice to know it won't be. Turns out my muffler and...
Forum: Hardbody Forum (D21) 03-03-2021, 06:10 PM
Replies: 38
Views: 1,726
Posted By KivPanther
I could use those pictures for sure. Put mine...

I could use those pictures for sure. Put mine back together and can’t figure out what’s squeaking.
Forum: Engine and Drivetrain 03-01-2021, 04:25 PM
Replies: 25
Views: 551
Posted By KivPanther
I couldn't notice a definitive dead spot on the...

I couldn't notice a definitive dead spot on the digital meter, but I DID notice that I could consistently get the engine to start doing the stumble parked under no load if I veeeery carefully held...
Forum: Project Build Log 03-01-2021, 04:23 PM
Replies: 24
Views: 1,005
Posted By KivPanther
Found out that my exhaust headers are cracked...

Found out that my exhaust headers are cracked today, so that's fun. Time for a whole new exhaust system sooner rather than later. Hey, maybe that'll improve my MPG a bit too, who knows?
Forum: Engine and Drivetrain 02-28-2021, 06:02 AM
Replies: 6
Views: 176
Posted By KivPanther
Don't worry about it. Those rails are tougher...

Don't worry about it. Those rails are tougher than they look, just make sure you only put enough pressure on the hose to get a good grip. Feel free to twist and yank until it comes off. You'll likely...
Forum: Engine and Drivetrain 02-28-2021, 02:42 AM
Replies: 6
Views: 176
Posted By KivPanther
You mean the little section that connects the two...

You mean the little section that connects the two rails together at the front? Hose pliers would make that easier if you don't want to take the rails off.
Forum: Hardbody Forum (D21) 02-27-2021, 07:39 PM
Replies: 23,111
Views: 1,696,823
Posted By KivPanther
Is yours a V6 or KA24E? If a 4-banger, there's a...

Is yours a V6 or KA24E? If a 4-banger, there's a post on here about the wax fast idle solenoid. Should be pinned.
Forum: Hardbody Forum (D21) 02-27-2021, 08:22 AM
Replies: 23,111
Views: 1,696,823
Posted By KivPanther
It is in fact a V6. I have a great local exhaust...

It is in fact a V6. I have a great local exhaust shop that'll be replacing it with a standard aftermarket muffler and cat. Unless the collector or manifold is broken, my quote is somewhere around...
Showing results 1 to 25 of 129

 
Forum Jump

All times are GMT. The time now is 09:13 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.