Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.10 seconds.
Search: Posts Made By: cadillacdude1975
Forum: Hardbody Forum (D21) Today, 12:57 AM
Replies: 10
Views: 95
Posted By cadillacdude1975
http://www.infamousnissan.com/forum/showthread.php...

http://www.infamousnissan.com/forum/showthread.php?t=25332

The article was written by someone that had a 94 model with the 4 cylinder.
Forum: Project Build Log Yesterday, 10:32 AM
Replies: 195
Views: 7,988
Posted By cadillacdude1975
Check the state laws on bonded titles. In...

Check the state laws on bonded titles. In Tennessee, it is possible to basically “buy” a title. There is a little paperwork required. The VIN has to be checked for a stolen report. Then an affidavit...
Forum: Engine and Drivetrain Yesterday, 02:09 AM
Replies: 1
Views: 16
Posted By cadillacdude1975
Maybe the idle valve is stuck. Recheck the...

Maybe the idle valve is stuck. Recheck the throttle cable tension. K
Recheck the baseplate seal.
Forum: Engine and Drivetrain Yesterday, 02:04 AM
Replies: 13
Views: 97
Posted By cadillacdude1975
When i deleted the damper on my truck, the pedal...

When i deleted the damper on my truck, the pedal got a lot stiffer. I had the clutch replaced about 10000 miles ago, and it has a very stout pedal now.
Forum: Engine and Drivetrain 12-01-2021, 02:38 AM
Replies: 13
Views: 97
Posted By cadillacdude1975
Yes the diaphragm breaks down and could possibly...

Yes the diaphragm breaks down and could possibly do that.
Forum: Project Build Log 12-01-2021, 02:31 AM
Replies: 195
Views: 7,988
Posted By cadillacdude1975
Cant get a title? Why not?

Cant get a title? Why not?
Forum: Engine and Drivetrain 11-30-2021, 12:17 AM
Replies: 13
Views: 97
Posted By cadillacdude1975
Delete the clutch damper and see if the problem...

Delete the clutch damper and see if the problem goes away.
Forum: Engine and Drivetrain 11-28-2021, 02:14 PM
Replies: 11
Views: 84
Posted By cadillacdude1975
It can’t hurt…. It may confirm what you already...

It can’t hurt…. It may confirm what you already think.
Forum: Project Build Log 11-28-2021, 05:54 AM
Replies: 195
Views: 7,988
Posted By cadillacdude1975
The aftermarket front windshield trim can be seen...

The aftermarket front windshield trim can be seen in the 5th pic. I do not remember what thread that discussion was in or who wanted the pic, but there ya go.
Forum: Project Build Log 11-28-2021, 05:50 AM
Replies: 195
Views: 7,988
Posted By cadillacdude1975
A few pictures. ...

A few pictures.

https://i.postimg.cc/mtTBCJBL/2-C458839-6-C0-D-465-B-8974-43-B1-DC5-C9-CA0.jpg (https://postimg.cc/mtTBCJBL)
...
Forum: Project Build Log 11-28-2021, 05:49 AM
Replies: 195
Views: 7,988
Posted By cadillacdude1975
Changed the master cylinder last week. Man it has...

Changed the master cylinder last week. Man it has brakes now lol
Forum: Early Frontier Forum (D22) 11-28-2021, 05:05 AM
Replies: 1
Views: 25
Posted By cadillacdude1975
I know the d21 and pathfinders used a bracket. I...

I know the d21 and pathfinders used a bracket. I added the map light to my 87 d21 and i had to cut the space so the bracket fit. The later model trucks all came with the trimming done from the...
Forum: Wiring and Electrical 11-28-2021, 05:03 AM
Replies: 3
Views: 31
Posted By cadillacdude1975
You are welcome. Hope you get it sorted out.

You are welcome. Hope you get it sorted out.
Forum: Engine and Drivetrain 11-28-2021, 05:01 AM
Replies: 11
Views: 84
Posted By cadillacdude1975
I assume you checked the oil pressure with a...

I assume you checked the oil pressure with a mechanical gauge?
Forum: Engine and Drivetrain 11-27-2021, 12:39 AM
Replies: 5
Views: 42
Posted By cadillacdude1975
The truck in the thread I posted was a 94 with...

The truck in the thread I posted was a 94 with the 4 cylinder.
Forum: Introductions 11-26-2021, 06:30 AM
Replies: 3
Views: 22
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: Hardbody Forum (D21) 11-26-2021, 06:23 AM
Replies: 18
Views: 200
Posted By cadillacdude1975
After I swapped my pathfinder engine, I added a...

After I swapped my pathfinder engine, I added a real temp gauge. I pulled one of the block drain plugs out and put the temp sensor there.


...
Forum: Engine and Drivetrain 11-26-2021, 06:20 AM
Replies: 5
Views: 42
Posted By cadillacdude1975
http://www.infamousnissan.com/forum/showthread.php...

http://www.infamousnissan.com/forum/showthread.php?t=25332
Forum: Engine and Drivetrain 11-26-2021, 06:15 AM
Replies: 5
Views: 42
Posted By cadillacdude1975
Those later trucks had a TSB about the main...

Those later trucks had a TSB about the main engine wire harness. The main symptom was the engine would be fine one minute then it would start bucking, jerking, hiccupping and just run like shit....
Forum: Introductions 11-26-2021, 06:07 AM
Replies: 5
Views: 64
Posted By cadillacdude1975
Does the truck have a trailer wiring harness?...

Does the truck have a trailer wiring harness? When these trucks were made, add-on trailer pigtails were the splice type. The problem with that is the hardbody uses a five wire system (left turn,...
Forum: Hardbody Forum (D21) 11-25-2021, 03:02 AM
Replies: 8
Views: 121
Posted By cadillacdude1975
The work style clamps have to be retightened...

The work style clamps have to be retightened every so often to avoid leaks. The best clamps are the Toyota style. Those are constant pressure clamps.
Forum: Hardbody Forum (D21) 11-25-2021, 02:57 AM
Replies: 18
Views: 141
Posted By cadillacdude1975
Manual transmission? If so, the rubber plug on...

Manual transmission? If so, the rubber plug on the clutch safe switch has probably crumbled. It will not start if that is what happened because the ECM still sees the clutch as not pressed.
Forum: Wiring and Electrical 11-24-2021, 01:53 AM
Replies: 17
Views: 679
Posted By cadillacdude1975
If it spins but does not engage the flywheel,...

If it spins but does not engage the flywheel, either the bendix is shot or the flywheel is missing several consecutive teeth.
Forum: Hardbody Forum (D21) 11-24-2021, 01:51 AM
Replies: 8
Views: 121
Posted By cadillacdude1975
Do you have the manual printed by nissan or a...

Do you have the manual printed by nissan or a shitty haynes manual? My nissan shop service manual has everything.
Forum: General Discussion 11-23-2021, 09:09 AM
Replies: 16
Views: 135
Posted By cadillacdude1975
The decals Kelyn has sold in the past were done...

The decals Kelyn has sold in the past were done to help with the monthly web hosting bill. He never sold them to get rich. The dude who makes them required a certain number before he would cut them....
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 02:22 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.