Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 341
Search took 0.01 seconds.
Search: Posts Made By: Scott Turchin
Forum: Im Looking For . . . 06-06-2021, 09:50 PM
Replies: 1
Views: 30
Posted By Scott Turchin
Looking for 95-97 EGR valve

Prefer low miles and functional.


But if you have one, I can always replace the diaphram.


It's going to be a PITA to change so I want to have one in hand..


Thanks,
Forum: Engine and Drivetrain 05-30-2021, 01:22 AM
Replies: 2
Views: 51
Posted By Scott Turchin
Egr?

After 8 months of diagnosing my 35mph vibration, 3 shops failed the test, I changed out rear wheel bearings and vibration went away. Changed out about $5k in parts ...new truck...



But, my cat...
Forum: Im Looking For . . . 05-21-2021, 04:00 AM
Replies: 0
Views: 47
Posted By Scott Turchin
WTB 95-97 4WD hub gear

THe engagement gears inside the hub, mechanic must have tapped it in, broke it...and I can't prove it b/c I've been battling that vibration for 8 months - (IT was calipers, despite being new they...
Forum: Engine and Drivetrain 03-03-2021, 04:36 AM
Replies: 6
Views: 176
Posted By Scott Turchin
Yeah...but.....Mine in the end turned out the...

Yeah...but.....Mine in the end turned out the Transfer Case was shot, u-joints installation issue (I'm guilty)....that mistake cost me $3500 and the truck is in very good hands...All About...
Forum: Engine and Drivetrain 02-04-2021, 03:34 AM
Replies: 6
Views: 176
Posted By Scott Turchin
Found my 36mph vibration!

Damn it's been a LONG 3 months chasing this thing.
I've changed bearings out twice, and last time on teh passenger side I found the grease seal spring (in addition to the existing seal/spring) on...
Forum: Engine and Drivetrain 01-10-2021, 12:02 AM
Replies: 12
Views: 323
Posted By Scott Turchin
BTW Problem was finally solved. Out of...

BTW Problem was finally solved.


Out of balance driveshaft and MOGUE ball joints don't go well, 4 year old ball joint snapped, or was close to it, and all 4 of those got replaced with Delta8 and...
Forum: Engine and Drivetrain 01-04-2021, 05:42 AM
Replies: 9
Views: 171
Posted By Scott Turchin
I do both sides typically but you also have to...

I do both sides typically but you also have to make sure both sides are perfectly clean, one bump can still cause an intake leak....


Remember, THIN is the key there...:)


Gaskets typically...
Forum: Engine and Drivetrain 01-04-2021, 01:00 AM
Replies: 9
Views: 171
Posted By Scott Turchin
Ultra-Black or Permatex Part 2b. THIN coat. ...

Ultra-Black or Permatex Part 2b.
THIN coat.


(Thin coat)
Forum: Engine and Drivetrain 01-03-2021, 10:38 PM
Replies: 12
Views: 323
Posted By Scott Turchin
Update: I put the drivers side rear tire...

Update:


I put the drivers side rear tire on the front, front on the back.
The vibration moved from the back to the front.
So I put my 31's on, and while they have their own low frequency...
Forum: Engine and Drivetrain 01-01-2021, 02:04 AM
Replies: 5
Views: 151
Posted By Scott Turchin
THere is no back edge...it goes inside the...

THere is no back edge...it goes inside the aluminum, there will only be a tiny spot where I can insert a hook on each side, hence using a puller.


I've used the upside down can of air, but a...
Forum: Engine and Drivetrain 12-31-2020, 05:02 PM
Replies: 5
Views: 151
Posted By Scott Turchin
Yeah this is what I thought. :( THe new...

Yeah this is what I thought. :(


THe new bearing just arrived, having it in hand will give me an idea of what i"m up against.


Factory manual shows like 2 steps removing it, with a special...
Forum: Engine and Drivetrain 12-31-2020, 05:26 AM
Replies: 5
Views: 151
Posted By Scott Turchin
4WD Transfer case rear bearing - ?

Rear bearing/seal - watched a youtube video where it can be changed out in the vehicle, special tool required.


Has anyone changed theirs?


Mine has slop, damage from the out of balance...
Forum: Engine and Drivetrain 12-31-2020, 03:32 AM
Replies: 12
Views: 323
Posted By Scott Turchin
SO what's involved with changing this bearing?...

SO what's involved with changing this bearing? Transfer case has to come out? Cover off from it? Or pop it off?


New bearing (Altrom) will be here tomorrow.


https://i.imgur.com/t4ykMnj.jpg?1
Forum: Engine and Drivetrain 12-30-2020, 09:02 PM
Replies: 12
Views: 323
Posted By Scott Turchin
OK so truck came to the shop and they...

OK so truck came to the shop and they conclusively diagnosed the output bearing on the transfer case is worn out. Is this a nightmare to change?
Forum: Engine and Drivetrain 12-30-2020, 04:07 PM
Replies: 2
Views: 146
Posted By Scott Turchin
Exhaust/CATS

SO as mentioned have reason to suspect my cat is on it's ay out, mushy uphill, heats up at highway speed, and the truck had a *LOT* of vibration recently (Driveshaft).


Driveshaft has been...
Forum: Engine and Drivetrain 12-30-2020, 03:57 PM
Replies: 12
Views: 323
Posted By Scott Turchin
Yup, looking back this started all about 8 months...

Yup, looking back this started all about 8 months ago.
I suspect my cat converter is going out, and if it ever stops raining I will go pull it and check it. But a new one is only $180 and the truck...
Forum: Engine and Drivetrain 12-30-2020, 03:25 AM
Replies: 12
Views: 323
Posted By Scott Turchin
So.......... Replaced all ball joints,...

So..........


Replaced all ball joints, one on passenger side was broken.
Replaced front brakes and rotors (yet again, but with ATM (Japan)).


Balanced driveshaft.
Forum: Engine and Drivetrain 12-21-2020, 11:35 PM
Replies: 12
Views: 323
Posted By Scott Turchin
Yep, replaced them and the seals last week,...

Yep, replaced them and the seals last week, double checked yesterday, front end is like brand new, ball joints, etc :) (All Altrom parts now)




However this coincides with my ABS light turning...
Forum: Engine and Drivetrain 12-21-2020, 03:05 AM
Replies: 12
Views: 323
Posted By Scott Turchin
Vibration issue - Drive Train

SO I have this vibration issue, thought it was coming from the front end but alas my brother came over and gave a hand and I replaced drive shafts,U-joints (Front, back was done a few weeks ago)...
Forum: Suspension 12-20-2020, 06:25 PM
Replies: 4
Views: 217
Posted By Scott Turchin
Right, so the tie rods I got from Rock Auto are...

Right, so the tie rods I got from Rock Auto are all normal threads (RH I assume).


dvdSwan - if you know anyone that could use those - free, as well as spare non-OEM taillights and rear brake...
Forum: Suspension 12-20-2020, 02:36 PM
Replies: 4
Views: 217
Posted By Scott Turchin
Tie rods - LH or RH thread?

I'm looking at replacing my tie rods, think the center link is gone and Altrom (Sansei 555 and Delta8) are OEM - but I have a 4WD, no steering stabilizer and am seeing a LOT of options for LH or RH...
Forum: Engine and Drivetrain 11-22-2020, 12:48 AM
Replies: 2
Views: 143
Posted By Scott Turchin
Slop on front shaft?

I've had a wobble I've been chasing for a while now.
1996 4WD
So after checking the obvious, alignment, brakes, tires etc....I went to the wheel bearings.

While changing out my brake pads today,...
Forum: Wiring and Electrical 10-03-2020, 04:45 PM
Replies: 5
Views: 202
Posted By Scott Turchin
So I had 10 flashes, went to diagnostic procedure...

So I had 10 flashes, went to diagnostic procedure 10 and had 1.30 kohms - means the ABS control module is defective.


Win win, it's $69, better than $400 :)


Thanks!!
Forum: Wiring and Electrical 10-03-2020, 04:23 AM
Replies: 5
Views: 202
Posted By Scott Turchin
They crushed all but 2 of them!!! Bummer. ...

They crushed all but 2 of them!!! Bummer.


Alabama - that procedure looks good, I just downloaded all of the manuals - will be on that one tomorrow for sure.


I believe the sensor is good,...
Forum: Wiring and Electrical 10-03-2020, 12:36 AM
Replies: 5
Views: 202
Posted By Scott Turchin
Exclamation ABS Light on (When rolling forward only)

I'm suspecting the rear sensor - on my Diff, (1996) is defective but really there's no way to know.
Obviously the vehicle KNOWS It's rolling - does not come on until rolling forward.


The part...
Showing results 1 to 25 of 341

 
Forum Jump

All times are GMT. The time now is 05:10 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.