Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: cadillacdude1975
Forum: Engine and Drivetrain 07-25-2021, 02:38 PM
Replies: 4
Views: 30
Posted By cadillacdude1975
https://www.amazon.com/dp/B074LT5B1M/ref=cm_sw_r_s...

https://www.amazon.com/dp/B074LT5B1M/ref=cm_sw_r_sms_api_glt_fabc_ACMM3P4VXS3Q6S00ZC32

Hands down the best direct LED swap out there. Period.
Forum: Engine and Drivetrain 07-25-2021, 02:33 PM
Replies: 4
Views: 30
Posted By cadillacdude1975
Welcome to IN. Typically the SE trim level...

Welcome to IN.

Typically the SE trim level had the V6 engine and all the interior bells and whistles like power windows and locks, sunroof etc. the V6 was discontinued in 95. Nissan had the 3.3 in...
Forum: Hardbody Forum (D21) 07-24-2021, 02:35 AM
Replies: 20
Views: 184
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: Wiring and Electrical 07-15-2021, 06:22 AM
Replies: 10
Views: 170
Posted By cadillacdude1975
My v6 d21 runs around halfway on the temp gauge....

My v6 d21 runs around halfway on the temp gauge. My vg33 swapped pathfinder dash gauge is shot. Need to disassemble the dash to replace the gauge. Not happening. I have a three gauge display under...
Forum: Introductions 07-15-2021, 06:16 AM
Replies: 8
Views: 91
Posted By cadillacdude1975
Welcome to IN. You will enjoy the site. ...

Welcome to IN. You will enjoy the site.

First of all, adding AC is way easier than you think. Nissan used a “universal” wire harness. That means the non AC trucks are already wired for AC. Check...
Forum: Introductions 07-15-2021, 06:07 AM
Replies: 7
Views: 57
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: Introductions 07-15-2021, 06:03 AM
Replies: 8
Views: 75
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: Hardbody Forum (D21) 07-15-2021, 06:02 AM
Replies: 13
Views: 148
Posted By cadillacdude1975
If the timing is way off it would lag hard when...

If the timing is way off it would lag hard when cranking.
Forum: General Discussion 07-15-2021, 06:00 AM
Replies: 12
Views: 105
Posted By cadillacdude1975
Yeah you will have to throw a big ass Nissan...

Yeah you will have to throw a big ass Nissan party lol
Forum: Engine and Drivetrain 07-08-2021, 01:02 AM
Replies: 3
Views: 69
Posted By cadillacdude1975
Check out the weber carb kit. The entire...

Check out the weber carb kit. The entire conversion kit costs about 500 bucks. It comes with everything needed for the TBI to carb swap on the vg30i and z24i engines. I have two of those kits. They...
Forum: Hardbody Forum (D21) 07-08-2021, 12:59 AM
Replies: 9
Views: 144
Posted By cadillacdude1975
It probably popped a fuse link.

It probably popped a fuse link.
Forum: Interior & Audio/Video 07-08-2021, 12:56 AM
Replies: 8
Views: 119
Posted By cadillacdude1975
Rough the belt pulley up with some sandpaper....

Rough the belt pulley up with some sandpaper. Removing the shine should help reduce that belt noise.
Forum: Engine and Drivetrain 07-03-2021, 01:25 AM
Replies: 27
Views: 398
Posted By cadillacdude1975
If it has a manual trans, the engine has to come...

If it has a manual trans, the engine has to come forward about three inches for the input shaft to clear the engine and clutch assembly. When the diff is in place, the pan hits the chunk. An...
Forum: Engine and Drivetrain 06-29-2021, 02:19 AM
Replies: 27
Views: 398
Posted By cadillacdude1975
Remove the front crossmember. One man job...

Remove the front crossmember. One man job reinstalling it with a transmission jack. I took mine out the regular way. I removed the rear crossmember after the chunk tilted down. It will pop out on the...
Forum: Hardbody Forum (D21) 06-27-2021, 12:20 AM
Replies: 13
Views: 216
Posted By cadillacdude1975
Changing all the orings, drier and expansion...

Changing all the orings, drier and expansion valve can be done in a couple of hours. I use clean motor oil to lube the orings.
Forum: Project Build Log 06-27-2021, 12:10 AM
Replies: 178
Views: 5,922
Posted By cadillacdude1975
Got his contact info handy?

Got his contact info handy?
Forum: Project Build Log 06-26-2021, 12:59 AM
Replies: 178
Views: 5,922
Posted By cadillacdude1975
Been loosing coolant. Passenger front carpet...

Been loosing coolant. Passenger front carpet soaked and slick. Damn heater core. I bypassed it for now. I refuse to tackle that pain in the ass in the summer. That will be an October repair.

Also...
Forum: Suspension 06-24-2021, 02:33 AM
Replies: 4
Views: 110
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: General Discussion 06-17-2021, 02:04 AM
Replies: 138
Views: 11,417
Posted By cadillacdude1975
https://i.postimg.cc/DJ6QwXW8/48-FD3-D4-B-6-F90-4-...

https://i.postimg.cc/DJ6QwXW8/48-FD3-D4-B-6-F90-4-E4-B-9-EB4-EF7-A6-B9-A21-D1.jpg (https://postimg.cc/DJ6QwXW8)

Scored a virtually new set of NGK wires and a very good SE cluster.
Forum: Hardbody Forum (D21) 06-14-2021, 08:24 PM
Replies: 5
Views: 115
Posted By cadillacdude1975
Bypassing it will not hurt anything.

Bypassing it will not hurt anything.
Forum: Wiring and Electrical 06-13-2021, 07:41 AM
Replies: 12
Views: 148
Posted By cadillacdude1975
Agreed.

Agreed.
Forum: Engine and Drivetrain 06-13-2021, 07:39 AM
Replies: 101
Views: 75,776
Posted By cadillacdude1975
The compressors are not cheap.

The compressors are not cheap.
Forum: Interior & Audio/Video 06-12-2021, 09:43 AM
Replies: 4
Views: 104
Posted By cadillacdude1975
Do not destroy the old carpet. You will need to...

Do not destroy the old carpet. You will need to use it as a template for everything…..the seat belt holes, seat bolts, gas pedal stop, the shifter etc.
Forum: Introductions 05-30-2021, 01:55 AM
Replies: 5
New
Views: 103
Posted By cadillacdude1975
Welcome to IN

Welcome to IN
Forum: Hardbody Forum (D21) 05-30-2021, 01:54 AM
Replies: 12
Views: 247
Posted By cadillacdude1975
Pull the cowl vent covers off and put some screen...

Pull the cowl vent covers off and put some screen under them. Problem solved.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 11:59 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.