Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: jp2code
Forum: Hardbody Forum (D21) Yesterday, 12:38 AM
Replies: 8
Views: 82
Posted By jp2code
Do you carry a voltmeter around in the truck? Or...

Do you carry a voltmeter around in the truck? Or can you?

The next time your Bosch voltmeter is showing odd outputs, pull over and see what the output of the alternator is with a real meter.

If...
Forum: Hardbody Forum (D21) Yesterday, 12:30 AM
Replies: 6
Views: 50
Posted By jp2code
I've never heard of the steering box itself going...

I've never heard of the steering box itself going out. It might leak or the gears might somehow strip, but I don't think there is much else to them.

Rockauto: 1993 Nissan D21 Pickup 2.4L Power...
Forum: Hardbody Forum (D21) 01-14-2022, 04:16 PM
Replies: 9
Views: 91
Posted By jp2code
Mine came from the dealership. Rockauto.com...

Mine came from the dealership. Rockauto.com certainly costs less, and usually they will order in bulk and sell them until they are gone. If you see 6 of them, I'd suggest snagging them while they are...
Forum: Hardbody Forum (D21) 01-14-2022, 03:18 PM
Replies: 9
Views: 91
Posted By jp2code
For the VG30e with the intake plenum, the labor...

For the VG30e with the intake plenum, the labor charge to remove the plenum so that you can get the fuel rail off is roughly $600 depending on what the shop's hourly rate is.

The injectors are all...
Forum: Hardbody Forum (D21) 01-12-2022, 02:09 AM
Replies: 23
Views: 182
Posted By jp2code
And I'm impressed! A used ECU from eBay is...

And I'm impressed!

A used ECU from eBay is $50 (if you are lucky) to $400.
Forum: Hardbody Forum (D21) 01-11-2022, 05:51 PM
Replies: 18
Views: 1,569
Posted By jp2code
Zach, How about an intro thread. You look...

Zach,

How about an intro thread. You look suspicious.

Moderators are supposed to watch out for accounts like yours.
Forum: Hardbody Forum (D21) 01-11-2022, 05:24 PM
Replies: 23
Views: 182
Posted By jp2code
Do the Fusible Links look recently added? ...

Do the Fusible Links look recently added?

The previous owner could have been running without fusible links when the problem occurred. There have been posts here where the owners didn't have them,...
Forum: Hardbody Forum (D21) 01-11-2022, 02:35 PM
Replies: 23
Views: 182
Posted By jp2code
Good find. Most owners don't dig that far in....

Good find. Most owners don't dig that far in. Finding bad spots on a board can be simple when they are blown that bad.

Which makes me ask why your ECU blew. Did you say that you do NOT have...
Forum: Hardbody Forum (D21) 01-11-2022, 01:19 AM
Replies: 23
Views: 182
Posted By jp2code
Usually, if the ECU is bad, the engine won't...

Usually, if the ECU is bad, the engine won't crank. So I'm inclined to rule that out.

In my signature below, I have a video where I recorded myself checking the codes on my 94. Watch it and...
Forum: Suspension 01-09-2022, 01:26 AM
Replies: 18
Views: 148
Posted By jp2code
Hey DVD, I was going through some settings on the...

Hey DVD, I was going through some settings on the Facebook D21Classifieds group and found you in the Blocked list. I had other admins in there for a while, so it was clearly someone else who did it -...
Forum: Wiring and Electrical 01-08-2022, 10:44 PM
Replies: 10
Views: 60
Posted By jp2code
Good to hear! You said you don't have any...

Good to hear!

You said you don't have any fusible links. Those are there to prevent electrical surges and spikes from damaging your fuel injectors and ECU. Surges and spikes can come from a...
Forum: Suspension 01-08-2022, 10:32 PM
Replies: 18
Views: 148
Posted By jp2code
The U-Bolts holding your springs on will get...

The U-Bolts holding your springs on will get loose if you didn't torque them down to 75-ft/lbs.

That's a lot, by the way!

When the U-Bolts get loose, it will sound a little bit like your axle...
Forum: Wiring and Electrical 01-08-2022, 10:30 PM
Replies: 10
Views: 60
Posted By jp2code
I had that happen, too. It was hard to diagnose.

I had that happen, too. It was hard to diagnose.
Forum: Hardbody Forum (D21) 01-06-2022, 01:03 AM
Replies: 23
Views: 264
Posted By jp2code
The service manual (see post 20 above) says to...

The service manual (see post 20 above) says to adjust by rotating the throttle sensor body so that the output voltage is 0.4 to 0.6V.

I'm guessing 1.5 k ohms is too high.
Forum: Hardbody Forum (D21) 01-06-2022, 12:48 AM
Replies: 23
Views: 264
Posted By jp2code
Hey Jason Bourne, Have you tried adjusting...

Hey Jason Bourne,

Have you tried adjusting the Throttle Sensor?

http://www.infamousnissan.com/forum/attachment.php?attachmentid=5015
d21_truck_1990 EC-316

Measure the output voltage with...
Forum: Hardbody Forum (D21) 01-06-2022, 12:42 AM
Replies: 9
Views: 133
Posted By jp2code
Mine is the same as theirs. Usually rides just a...

Mine is the same as theirs. Usually rides just a tad above the cold setting.
Forum: Hardbody Forum (D21) 01-05-2022, 10:13 PM
Replies: 23
Views: 264
Posted By jp2code
The Check Engine Light (CEL) is only to indicate...

The Check Engine Light (CEL) is only to indicate emissions problems. You won't generally see it unless your O2 sensors are bad.

The TPS device should change its Ohm value depending on where the...
Forum: Hardbody Forum (D21) 01-05-2022, 09:13 PM
Replies: 23
Views: 264
Posted By jp2code
That sounds like what I would think. Idles normal...

That sounds like what I would think. Idles normal with the TPS disconnected, but starts running bad when the RPM goes up because the engine needs the TPS data.

Did you say you replaced the TPS...
Forum: Hardbody Forum (D21) 01-05-2022, 08:43 PM
Replies: 23
Views: 264
Posted By jp2code
I've never done it, but I thought unplugging the...

I've never done it, but I thought unplugging the TPS sensor simply bypassed the sensor, but that it would run decent at idle. I've never done it, though, and my engine is the V6.

Have you checked...
Forum: Hardbody Forum (D21) 01-04-2022, 02:45 PM
Replies: 8
Views: 88
Posted By jp2code
+1 You are still going to need a big wrench...

+1

You are still going to need a big wrench to get the old one off, though.
Forum: Hardbody Forum (D21) 01-04-2022, 11:57 AM
Replies: 8
Views: 88
Posted By jp2code
Or the airflow is clogged up. Get a wrench...

Or the airflow is clogged up.

Get a wrench that fits the big EGR nut. I can't remember if it is a 22mm or 24mm, but you certainly want an actual wrench instead of an adjustable wrench or a pipe...
Forum: Hardbody Forum (D21) 01-03-2022, 01:12 PM
Replies: 23
Views: 282
Posted By jp2code
I have heard reports of tires that just never...

I have heard reports of tires that just never worked before. Certainly mixing and matching radials with bias-ply tires will cause driving issues, so it isn't impossible that you just have a bad set...
Forum: Hardbody Forum (D21) 01-01-2022, 07:08 PM
Replies: 31
Views: 269
Posted By jp2code
200-mile commute? That's going to be one helluva...

200-mile commute? That's going to be one helluva shakedown!

Maybe try going to the grocery store a few times first.
Forum: Introductions 12-31-2021, 06:21 PM
Replies: 12
Views: 101
Posted By jp2code
If you decide on adding AC, we have a write-up on...

If you decide on adding AC, we have a write-up on how it's done:

Thread How to: Retrofitting A/C
Forum: Hardbody Forum (D21) 12-30-2021, 07:57 PM
Replies: 23
Views: 282
Posted By jp2code
Fingers crossed. Hopefully, that will get rid of...

Fingers crossed. Hopefully, that will get rid of your issue. Not sure how, but hopefully.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 04:56 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.