Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: Reserector
Forum: Hardbody Forum (D21) Yesterday, 05:38 PM
Replies: 15
Views: 91
Posted By Reserector
dvdswan nailed it. I have a HG46 with...

dvdswan nailed it.

I have a HG46 with limited slip diff from a 94 Pathfinder SE. Disc brakes. It is currently behind a 5.3L Chevy v8. The Nissan axles are stronger than any 8.8 IMHO. I cut...
Forum: Hardbody Forum (D21) Yesterday, 05:16 PM
Replies: 12
Views: 4,550
Posted By Reserector
Great job on this. Also, good call on getting...

Great job on this. Also, good call on getting the Sway-A-Way t-bars. I loved mine.


A word of caution, though:
You mentioned using heat to free the t-bars from rear anchors. I would advise...
Forum: Wiring and Electrical Yesterday, 11:49 AM
Replies: 5
Views: 32
Posted By Reserector
You may have to change the ECU as well. ...

You may have to change the ECU as well.

One thing I know about the '96 is that it had a position sensor in the top center of the bell housing. You '92 likely doesn't have that. At least not...
Forum: Wiring and Electrical 09-14-2021, 09:33 PM
Replies: 5
Views: 32
Posted By Reserector
'96 and '97 only came with 4 cyl. Go sit in the...

'96 and '97 only came with 4 cyl. Go sit in the corner.
Forum: Hardbody Forum (D21) 09-14-2021, 09:23 PM
Replies: 23,459
Views: 1,725,847
Posted By Reserector
I could never sell the FM. Not because I won't...

I could never sell the FM. Not because I won't part with it, but because the online ads limit you to a 500 word description of the vehicle for sale.
Forum: Engine and Drivetrain 09-13-2021, 03:22 PM
Replies: 10
Views: 342
Posted By Reserector
There is a washer with an internal bevel on the...

There is a washer with an internal bevel on the OEM axles that creates a square shoulder on the stub axle. Without that, the base of the stub has a radius that will not seat properly.
Anywho, I...
Forum: Shows and Get Togethers 08-31-2021, 05:40 PM
Replies: 1
Views: 42
Posted By Reserector
September Camping in Alabama

I will be camping at Service Park Campground in Coffeeville, Alabama on the 16th through the 18th of September (2021) It is right on the Tombigbee River.

If that interests you at all, here is the...
Forum: Hardbody Forum (D21) 08-27-2021, 05:48 PM
Replies: 23,459
Views: 1,725,847
Posted By Reserector
I can stand up in this: You could do a smaller...

I can stand up in this:
You could do a smaller frame, foam walls covered in poor man's fiberflass, leave out the heavy cabinets and toilet. Probably could build a glorified shell that is 1,500 lbs...
Forum: Introductions 08-25-2021, 05:34 PM
Replies: 3
Views: 51
Posted By Reserector
Lifted Drifter. Be a game changer.

Lifted Drifter. Be a game changer.
Forum: Hardbody Forum (D21) 08-25-2021, 03:39 PM
Replies: 4
Views: 98
Posted By Reserector
I put an aftermarket electric kit in mine. Tap...

I put an aftermarket electric kit in mine. Tap the button and THWACK! Well, maybe not that quick, but pretty quick. Did that six years ago. Easy to do from what I recall.


A single revolution...
Forum: Hardbody Forum (D21) 08-24-2021, 11:58 AM
Replies: 23,459
Views: 1,725,847
Posted By Reserector
Been running an antique tag for years now in...

Been running an antique tag for years now in Mississippi. It's my DD. Here it's pretty much a free tag after the initial purchase. I take real good care to not damage it.
Forum: Wiring and Electrical 08-20-2021, 09:32 PM
Replies: 5
Views: 53
Posted By Reserector
I never saw the advantage of LEDs, to be honest. ...

I never saw the advantage of LEDs, to be honest. I never found any that would fully illuminate the lenses like the standard bulbs. Standard bulbs last a long time.


Hyper flashing could cause...
Forum: Hardbody Forum (D21) 08-20-2021, 05:36 PM
Replies: 23,459
Views: 1,725,847
Posted By Reserector
Nice shot!

Nice shot!
Forum: The Datsun Era 08-19-2021, 05:48 PM
Replies: 4
Views: 62
Posted By Reserector
2wd or 4x4?

2wd or 4x4?
Forum: Hardbody Forum (D21) 08-17-2021, 10:01 PM
Replies: 1
Views: 40
Posted By Reserector
It was six years ago that I did my upholstery, so...

It was six years ago that I did my upholstery, so it's not fresh in my mind, but try this: With all of the hog rings out and nothing else holding it, pull the cover off from the bottom, turning it...
Forum: Interior & Audio/Video 08-17-2021, 05:39 PM
Replies: 4
Views: 69
Posted By Reserector
Remove the plastics at the bottom of the door...

Remove the plastics at the bottom of the door jamb. That will allow you to flush the rocker panels. You may have to clear the drains, but filling them with water should make them obvious.


I...
Forum: Hardbody Forum (D21) 08-17-2021, 05:31 PM
Replies: 6
Views: 79
Posted By Reserector
The only time my low fuel light ever worked was...

The only time my low fuel light ever worked was when the alternator was failing. One or two of the diodes in the rectifier had burned "open" allowing alternating current to flow and cause dash light...
Forum: Wiring and Electrical 08-13-2021, 02:46 PM
Replies: 13
Views: 176
Posted By Reserector
Won't work with a test light. Run to Harbor...

Won't work with a test light. Run to Harbor Freight and pick up a multi-meter. Put it on the continuity setting. Usually has a diode symbol. -l>l-
Forum: Hardbody Forum (D21) 08-11-2021, 05:25 PM
Replies: 12
Views: 160
Posted By Reserector
Or... Tighten the bracket back down. ...

Or...


Tighten the bracket back down.
Get a shorter belt. An inch shorter may be enough to get it back into the slot that you have, but I would try two inches shorter.
Install the shorter...
Forum: Project Build Log 08-11-2021, 02:47 PM
Replies: 1,050
Views: 251,831
Posted By Reserector
You won't be hauling anything but A$$ in that...

You won't be hauling anything but A$$ in that rig. :)
remember: Facebook doesn't care, nor remember like is forum folks do. ;)
Forum: Wiring and Electrical 08-06-2021, 02:37 PM
Replies: 5
Views: 77
Posted By Reserector
That makes you at least five years older than me....

That makes you at least five years older than me. :eye popping:
Forum: Hardbody Forum (D21) 08-06-2021, 12:02 PM
Replies: 23,459
Views: 1,725,847
Posted By Reserector
You finally got the "in tent"?

You finally got the "in tent"?
Forum: Engine and Drivetrain 08-06-2021, 11:57 AM
Replies: 7
Views: 78
Posted By Reserector
Yep. What he said. ^^^^

Yep. What he said. ^^^^
Forum: Hardbody Forum (D21) 08-05-2021, 09:32 PM
Replies: 23,459
Views: 1,725,847
Posted By Reserector
Nice petina AND it's a Caper Special to boot!

Nice petina AND it's a Caper Special to boot!
Forum: Project Build Log 08-05-2021, 02:56 PM
Replies: 138
Views: 3,293
Posted By Reserector
The PS hose from the pump is pressurized (when...

The PS hose from the pump is pressurized (when the engine is running). The hose/s that attach with hose clamps are not pressurized.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 09:46 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.