Go Back   Infamous Nissan - Hardbody / Frontier Forums > Tech Area > Wheels and Tires
Reload this Page Official wheel thread
Mark Forums Read
IN Store Register FAQ Members List Calendar Search Today's Posts

Reply
Page 5 of 6 « First 34 5 6
 
Thread Tools Display Modes
Old 09-09-2021, 07:25 AM   #41
rustytexasD21
 
rustytexasD21's Avatar
 
Join Date: May 2013
Location: Texas
Age: 30
Posts: 406
Vehicle: 1992 2400 manual 2wd
Thanks: 19
Thanked 45 Times in 36 Posts
Default
$120 Facebook marketplace find

- Wheel Brand - US wheel blade series 24
- Diameter - 15
- Width -
- Offset/Back spacing -
- Suspension modifications - 2” rear blocks
- Tire Sizes - 215/70/15

I need better pics

0AA8CEBB-79C5-4C74-B4AC-CD2566D91200.jpeg

C7F3E02D-686D-49CF-9850-96A9C0192552.jpeg
rustytexasD21 is offline   Reply With Quote
Thanked by:
alabama_lowlife (09-09-2021)
Old 11-09-2021, 05:27 PM   #42
MysticMathias
 
Join Date: Nov 2015
Location: Bentonville, AR
Posts: 28
Vehicle: 92 Reg Cab D21 coated in Grey Patina
Thanks: 6
Thanked 6 Times in 6 Posts
Default
Quote:
Originally Posted by TrqMnstr View Post
- Wheel Brand: Nismo Titan wheels
- Diameter: 18"
- Width: 8"
- Offset/Back spacing: +25 mm
- Suspension modifications: Torsioned front end. No front bump stops. 3" blocks, clamped rear leaves for an additional 1". No rear bump stops. Front and rear sway bars.
- fender modifications: None yet.....
- Tire Sizes: Front tires 235/40ZR18, Rear tires 245/40ZR18 Nexen N3000
-I need stiffer front end. These pictures are before the current tires and leaf clamps.
Very clean! Just dropped my set off at the machine shop, then shipping two of them maybe all 4 to get widened to 9" on the back side. I'll take measurements before hand to know of everything clears. Are you running 4x4 fenders? Can't tell.
MysticMathias is offline   Reply With Quote
Old 11-09-2021, 11:52 PM   #43
89'HBV6
Ol'school Geek
 
89'HBV6's Avatar
 
Join Date: Mar 2020
Location: Washington State / the Left Coast
Posts: 1,509
Vehicle: 89' D21 KC SE V6 5spd 2WD - 87' D21 KC SE V6 5spd 2WD
Thanks: 1,230
Thanked 362 Times in 329 Posts
Default
Quote:
Originally Posted by MysticMathias View Post
Very clean! Just dropped my set off at the machine shop, then shipping two of them maybe all 4 to get widened to 9" on the back side. I'll take measurements before hand to know of everything clears. Are you running 4x4 fenders? Can't tell.
Did you see that you replied to a 2014 post and the poster has not been around for almost 5 years? (just sayin')


__________________
. . . Factory Service Manuals: https://www.nicoclub.com/nissan-service-manuals
Quote:
Originally Posted by Deerhurst
What he is saying is the aerodynamics of a D21 is a brick in the wind.
Probably at least as bad as a Jeep so worse than a cow.
89'HBV6 is offline   Reply With Quote
Old 11-10-2021, 12:05 AM   #44
MysticMathias
 
Join Date: Nov 2015
Location: Bentonville, AR
Posts: 28
Vehicle: 92 Reg Cab D21 coated in Grey Patina
Thanks: 6
Thanked 6 Times in 6 Posts
Default
Quote:
Originally Posted by 89'HBV6 View Post
Did you see that you replied to a 2014 post and the poster has not been around for almost 5 years? (just sayin')
Is that against forum rules?
MysticMathias is offline   Reply With Quote
Old 11-10-2021, 12:19 AM   #45
89'HBV6
Ol'school Geek
 
89'HBV6's Avatar
 
Join Date: Mar 2020
Location: Washington State / the Left Coast
Posts: 1,509
Vehicle: 89' D21 KC SE V6 5spd 2WD - 87' D21 KC SE V6 5spd 2WD
Thanks: 1,230
Thanked 362 Times in 329 Posts
Default
Quote:
Originally Posted by MysticMathias View Post
Is that against forum rules?
No, but telling you that your question will probably never get an answer. (again, just sayin')


__________________
. . . Factory Service Manuals: https://www.nicoclub.com/nissan-service-manuals
Quote:
Originally Posted by Deerhurst
What he is saying is the aerodynamics of a D21 is a brick in the wind.
Probably at least as bad as a Jeep so worse than a cow.
89'HBV6 is offline   Reply With Quote
Old 04-12-2022, 10:08 PM   #46
vailm11
 
Join Date: Jan 2022
Location: Colorado
Posts: 2
Vehicle: 1993 D21 2.4L 4x4
Thanks: 0
Thanked 0 Times in 0 Posts
Default
Wheels: 2006-2009 Toyota 4Runners
Diameter: 18"
Width: 7.5"
Offset: +25mm
Suspension modifications: Clamped front of rear springs, torsioned down, about 1.5" front and rear (4x4 is not lower friendly, pending mono-leaf and more turned torsions)
- Tire Size: 225/60/18 Firestone Destination LE2






Previous setup:

Wheels: American Eagle Series 102
Diameter: 16"
Width: 10"
Offset: -24mm
Tires: 245/70R16 Atturo Trail Blade
Suspension modifications: Clamped front of rear springs, torsioned down, about 1.5" front and rear

These fuckers poked so far that even 4x4 Flares didn't cover tire completely. Went to the toyotas because it was impossible to keep this clean, and this truck doesn't get offroaded. Winter set now
vailm11 is offline   Reply With Quote
Old 04-24-2022, 06:09 PM   #47
rustytexasD21
 
rustytexasD21's Avatar
 
Join Date: May 2013
Location: Texas
Age: 30
Posts: 406
Vehicle: 1992 2400 manual 2wd
Thanks: 19
Thanked 45 Times in 36 Posts
Default
Changed wheels again lmao

Wheels $80 Facebook marketplace find that I put new tires on.

- Wheel Brand - Not sure help me out lol (center caps say pacer but idk)
- Diameter - 15
- Width -
- Offset/Back spacing -
- Suspension modifications - 2” rear blocks
- Tire Sizes - 205/65/15

4724A69F-3684-4DD0-8865-0CEA5662D540.jpeg
rustytexasD21 is offline   Reply With Quote
Old 05-22-2022, 02:38 AM   #48
supersayianjim
ka-t pathy
 
supersayianjim's Avatar
 
Join Date: Sep 2018
Location: location-x
Posts: 252
Vehicle: wd21 pathfinder 1987
Thanks: 24
Thanked 39 Times in 30 Posts
Default
what do you guys think about these wheels?

https://enkei.com/shop/wheels/truck-suv/cyclone/
__________________
ka24de-t 2dr 4x4 5spd pathfinder with
-264 cams
-xessive intake manifold
-450wally pump
-full 3" exhaust
-holset hx35
-1kcc bosch ev14 injectors
-Nismotronics ecu
-Arp main, head, rod bolt studs
-cometic mls
-decked refreshed head
-.10 over cast piston rebuilt bottom end
supersayianjim is offline   Reply With Quote
Old 05-22-2022, 12:30 PM   #49
alabama_lowlife
Owner and Administrator
 
alabama_lowlife's Avatar
 
Join Date: Sep 2008
Location: jack, alabama
Age: 42
Posts: 10,816
Vehicle: 2012 370Z, 1970 Datsun 521, 1995 Nissan Hardbody x2
Thanks: 1,108
Thanked 2,244 Times in 1,841 Posts
Default
I love that style of wheel
__________________
alabama_lowlife is offline   Reply With Quote
Old 05-23-2022, 01:07 AM   #50
rustytexasD21
 
rustytexasD21's Avatar
 
Join Date: May 2013
Location: Texas
Age: 30
Posts: 406
Vehicle: 1992 2400 manual 2wd
Thanks: 19
Thanked 45 Times in 36 Posts
Default
Quote:
Originally Posted by supersayianjim View Post
what do you guys think about these wheels?

https://enkei.com/shop/wheels/truck-suv/cyclone/
Oh yea pull the trigger
rustytexasD21 is offline   Reply With Quote
Reply
Page 5 of 6 « First 34 5 6

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 08:16 AM.

Contact Us - Infamous Nissan - Archive - Top

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.