Going back to stock height - Infamous Nissan

Hawaii 95 hardbody · 02-23-2021, 12:09 AM

So we picked up a dropped 95 hardbody, but want to bring it back to stock height. Was looking for tutorials, but no luck. Need help/advice- thanks in advance

89'HBV6 · 02-23-2021, 12:27 AM

Welcome to IN.

Do you have any junk yards in your area? I know, HI is probably slack for this, but it's a resource many use. If so, I'd suggest you do a bit of research to see what used parts trucks are available there.

I'm sure others will chime in. GL.....

PoBoi850 · 02-23-2021, 03:07 PM

Go to RockAuto.com and look at parts and part #'s for 95 hardbody 2wd stuff. That should get you at least a decent start on "what" to get. You don't have to use RA after you get the info you need.

alabama_lowlife · 02-23-2021, 06:26 PM

Well, it basically depends on exactly HOW it’s been lowered. It could just require removing the lowering blocks and adjusting the torsion bars back up. It could also need much, much more than that.

02-23-2021, 12:09 AM	#1
Hawaii 95 hardbody Join Date: Feb 2021 Location: HI Posts: 1 Vehicle: 95 Nissan 2W pickup Thanks: 0 Thanked 0 Times in 0 Posts	Going back to stock height So we picked up a dropped 95 hardbody, but want to bring it back to stock height. Was looking for tutorials, but no luck. Need help/advice- thanks in advance

02-23-2021, 03:07 PM	#3
PoBoi850 Join Date: Aug 2019 Location: Tallahassee Posts: 599 Vehicle: 88 Nissan Truck Thanks: 238 Thanked 65 Times in 59 Posts	Go to RockAuto.com and look at parts and part #'s for 95 hardbody 2wd stuff. That should get you at least a decent start on "what" to get. You don't have to use RA after you get the info you need. __________________ https://www.instagram.com/p/B9xQ5v_h...=1sufmtnljrva8

02-23-2021, 06:26 PM	#4
alabama_lowlife Owner and Administrator Join Date: Sep 2008 Location: jack, alabama Age: 41 Posts: 10,323 Vehicle: 2012 370Z, 1970 Datsun 521, 1995 Nissan Hardbody x2 Thanks: 965 Thanked 2,051 Times in 1,689 Posts	Well, it basically depends on exactly HOW it’s been lowered. It could just require removing the lowering blocks and adjusting the torsion bars back up. It could also need much, much more than that. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-23-2021, 12:27 AM	#2
89'HBV6 Ol'school Geek Join Date: Mar 2020 Location: Washington State Posts: 349 Vehicle: 89' D21 KingCab SE V6 5spd 2WD - 87' D21 KingCab SE V6 5spd 2WD Thanks: 397 Thanked 92 Times in 78 Posts	Welcome to IN. Do you have any junk yards in your area? I know, HI is probably slack for this, but it's a resource many use. If so, I'd suggest you do a bit of research to see what used parts trucks are available there. I'm sure others will chime in. GL.....