Go Back   Infamous Nissan - Hardbody / Frontier Forums > Tech Area > Engine and Drivetrain

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-13-2015, 02:28 PM   #1
jp2code
Software Developer
 
jp2code's Avatar
 
Join Date: Dec 2011
Location: Longview, TX [USA]
Age: 49
Posts: 8,888
Vehicle: 94 LB 2x4 Manual VG33e
Thanks: 1,292
Thanked 1,106 Times in 976 Posts
Default Oil Filter for VG30 2x4 with Headers

If any of you are brave enough to install headers on a 2x4 truck with the V6 engine, you will need to install this filter:

K&N HP-1010

The standard Nissan filter has too large of a diameter to fit out of the gap between the headers and the engine frame on the 2x4 trucks.

The K&N HP-1010 is about an inch less in diameter, so it just squeezes in.

The charts I see all say that this filter does not fit the VG30 engine, but it does.

Generally, I swap my oil only in the fall but do a full oil and filter swap in the spring. Since this K&N is a little smaller, I may start replacing the oil filter at each oil change.

Does anyone have any input on this, good or bad?
__________________
Joe (not a mechanic!) Don't have an account? EMAIL ME
Factory Service Manuals: https://www.nicoclub.com/FSM/Hardbody/
Walk-through: Checking Nissan Trouble Codes
1994 VG30E to VG33E with H256 Cams

jp2code is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 03:18 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.