Cluster lights - Infamous Nissan

Itsjacob04 · 02-09-2016, 02:42 AM

So I went ahead and swapped out the old cluster lights for some green ones to match the truck, what you guys think?

highest_vision · 02-09-2016, 03:38 AM

Did you roll your truck?? Looks good to me!

alabama_lowlife · 02-09-2016, 10:10 AM

Yeah that looks damn good

J Kittrell · 02-09-2016, 02:05 PM

How did you do that? Was it hard?

hardbodyhero · 02-09-2016, 02:28 PM

Pull your codes, CEL is on, lol

Itsjacob04 · 02-09-2016, 04:38 PM

lol i have a shit ton of exhaust codes, but the swap was not hard at all, you have to full the bottom panel of the truck under the sterring wheel, which is two screws and pull out,
then you unscrew the plastic covers off your sterring colum, which is four srews nd pull them apart.

then you have 4 screws that hold your cluster, at least for me i have a 96, i didn't unplug anything off the cluster seeing as i have horrible luck, so i just gently pulled the cluster out enough where i can unscrew the little red tabs that hold the light replace the bulb with 194's from superbrightleds.com in whatever color you choose and screw back in. TEST THEM BEFORE PUTTING IT BACK TOGETHER! trust just makes life better, i did it in 40 mins with a help of my buddy holding a flashlight in my driveway lol but in the day time i could do it in half the time.

hopefully today im going to change my climate control light and hopefully put it to green as well if the auto parts can find out the bulb, ill probably make a thread because i tore it apart yesterday and i was there for easily an hour carefully taking things apart to figure out where the light is

HB06 · 02-19-2016, 12:51 PM

{QUOTE}hopefully today im going to change my climate control light and hopefully put it to green as well if the auto parts can find out the bulb, ill probably make a thread because i tore it apart yesterday and i was there for easily an hour carefully taking things apart to figure out where the light is[/QUOTE]

Mine is burnt out also. How hard was it to change this one.

hardbodyhero · 02-19-2016, 02:17 PM

Easy- I believe its a type 74....that number comes to mind.

Pull your center bezel out....then I think there are a couple of screws?

I know that you have to pull off the selector knobs and pry one corner out of the panel front (the one with the temperature bar from hot to cold). Or you can pull in the center...but be careful.... that bitch can snap

Then there is the clear plastic diffuser that sends the light out from left to right, that comes out the same way.

Bulb is in center...might need a pair of needle nose to get it out, don't pinch too hard.

Ven · 02-19-2016, 02:59 PM

I would like to do this as well, need to get an interior back in mine first tho...lol

Itsjacob04 · 02-22-2016, 06:43 PM

Quote:

Originally Posted by HB06

{QUOTE}hopefully today im going to change my climate control light and hopefully put it to green as well if the auto parts can find out the bulb, ill probably make a thread because i tore it apart yesterday and i was there for easily an hour carefully taking things apart to figure out where the light is

Mine is burnt out also. How hard was it to change this one.[/QUOTE]

its not to hard but it is a b**ch to get the new light on, im currently in the process of figuring out what size the light is so ill let you guys know how that goes

02-09-2016, 03:38 AM	#2
highest_vision Join Date: Feb 2015 Location: Creston NC/Blairsville GA USA Posts: 259 Vehicle: 1995 Hardbody Thanks: 28 Thanked 31 Times in 29 Posts	Did you roll your truck?? Looks good to me! __________________ James 1995 Hardbody XE 4x4 5 speed 1985 720 Z24 5 speed Several 2 wheeled things

02-09-2016, 10:10 AM	#3
alabama_lowlife Owner and Administrator Join Date: Sep 2008 Location: jack, alabama Age: 38 Posts: 8,619 Vehicle: 2011 Nissan Frontier, 08 altima, 1970 Datsun 521, 1995 Nissan Hardbody Thanks: 481 Thanked 1,470 Times in 1,206 Posts	Yeah that looks damn good __________________ INfamous Nissan Shirt Pre-order!

02-09-2016, 02:28 PM	#5
hardbodyhero SONIC BOOM))))))))))))))) Join Date: Jun 2014 Location: Pine, Louisiana Age: 38 Posts: 1,936 Vehicle: 1996 Nissan Hardbody King Cab Auto Thanks: 147 Thanked 185 Times in 163 Posts	Pull your codes, CEL is on, lol __________________ Me and Tony and Islandboyz are paisanos

02-09-2016, 04:38 PM	#6
Itsjacob04 Join Date: Jan 2016 Location: Miami Age: 20 Posts: 85 Vehicle: 96 Nissan HB Thanks: 5 Thanked 3 Times in 3 Posts	lol i have a shit ton of exhaust codes, but the swap was not hard at all, you have to full the bottom panel of the truck under the sterring wheel, which is two screws and pull out, then you unscrew the plastic covers off your sterring colum, which is four srews nd pull them apart. then you have 4 screws that hold your cluster, at least for me i have a 96, i didn't unplug anything off the cluster seeing as i have horrible luck, so i just gently pulled the cluster out enough where i can unscrew the little red tabs that hold the light replace the bulb with 194's from superbrightleds.com in whatever color you choose and screw back in. TEST THEM BEFORE PUTTING IT BACK TOGETHER! trust just makes life better, i did it in 40 mins with a help of my buddy holding a flashlight in my driveway lol but in the day time i could do it in half the time. hopefully today im going to change my climate control light and hopefully put it to green as well if the auto parts can find out the bulb, ill probably make a thread because i tore it apart yesterday and i was there for easily an hour carefully taking things apart to figure out where the light is __________________ 96 Hardbody ka24e KA-T or SR???

02-19-2016, 02:17 PM	#8
hardbodyhero SONIC BOOM))))))))))))))) Join Date: Jun 2014 Location: Pine, Louisiana Age: 38 Posts: 1,936 Vehicle: 1996 Nissan Hardbody King Cab Auto Thanks: 147 Thanked 185 Times in 163 Posts	Easy- I believe its a type 74....that number comes to mind. Pull your center bezel out....then I think there are a couple of screws? I know that you have to pull off the selector knobs and pry one corner out of the panel front (the one with the temperature bar from hot to cold). Or you can pull in the center...but be careful.... that bitch can snap Then there is the clear plastic diffuser that sends the light out from left to right, that comes out the same way. Bulb is in center...might need a pair of needle nose to get it out, don't pinch too hard. __________________ Me and Tony and Islandboyz are paisanos

02-09-2016, 02:05 PM	#4
J Kittrell Join Date: Jan 2014 Location: Mobile, AL Posts: 29 Vehicle: 1995 Nissan truck Thanks: 0 Thanked 1 Time in 1 Post	How did you do that? Was it hard?

02-19-2016, 12:51 PM	#7
HB06 Join Date: Feb 2015 Location: SC Posts: 127 Vehicle: 1995 Hardbody Nissan Thanks: 2 Thanked 3 Times in 3 Posts	{QUOTE}hopefully today im going to change my climate control light and hopefully put it to green as well if the auto parts can find out the bulb, ill probably make a thread because i tore it apart yesterday and i was there for easily an hour carefully taking things apart to figure out where the light is[/QUOTE] Mine is burnt out also. How hard was it to change this one.

02-19-2016, 02:59 PM	#9
Ven ///Relaxed Atmosphere Join Date: Sep 2008 Location: Sunny Florida Posts: 1,898 Vehicle: 1994 Pathfinder Thanks: 144 Thanked 228 Times in 188 Posts	I would like to do this as well, need to get an interior back in mine first tho...lol __________________ ///RELAXED ATMOSPHERE - FL CHAPTER - NATION'S FINEST

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode