Infamous Nissan - Hardbody / Frontier Forums - View Single Post

95KingCab · 11-23-2020, 12:11 AM

Good evening friends,

I was wondering if someone could please do me a solid... I am having an issue where my temp gauge in my 1995 Ka24e hardbody isn't coming up to the where it used to sit when at full operating temp- a needle below 1/2. It now only goes to 1/5 at best... For those of you whose temp comes up to just under 1/2, would you please measure the ohms/resistance that your temp sender is at when at 1/2 on your temp gauge? With the volt meter set to ohms and your temp gauge to 1/2, please put one prong of the meter on the sending unit and one prong to a ground, and let me know what you get? I would suuuper appreciate your help!

Thank you thank you thank you!!!

11-23-2020, 12:11 AM	#1
95KingCab Join Date: Nov 2020 Location: Vancouver, WA Posts: 32 Vehicle: Nissan Pickup 1995 XE KA24E Thanks: 13 Thanked 0 Times in 0 Posts	Can Someone Do Me a Solid Please? Good evening friends, I was wondering if someone could please do me a solid... I am having an issue where my temp gauge in my 1995 Ka24e hardbody isn't coming up to the where it used to sit when at full operating temp- a needle below 1/2. It now only goes to 1/5 at best... For those of you whose temp comes up to just under 1/2, would you please measure the ohms/resistance that your temp sender is at when at 1/2 on your temp gauge? With the volt meter set to ohms and your temp gauge to 1/2, please put one prong of the meter on the sending unit and one prong to a ground, and let me know what you get? I would suuuper appreciate your help! Thank you thank you thank you!!!