View Single Post
Old 09-20-2021, 02:56 AM   #1
low&slo ka24
 
low&slo ka24's Avatar
 
Join Date: May 2021
Location: Xenia, Ohio
Posts: 45
Vehicle: ‘93 Nissan 850 L4
Thanks: 3
Thanked 0 Times in 0 Posts
Default Again, Transmission noise

Alright, noise from bell housing area. Just did throwout bearing, the bearing was shot. Input shaft bearing is still okay. Flywheel, clutch, and pressure plate are okay. The part that slides on the input shaft and connects to the fork is cast and had a crack at the back, possibly contacting the trans and making noise. (Previous owner was into “clutch kick drifting” and probably cracked the bearing race.) Any suggestions before I replace the whole clutch release assembly?
__________________
“Great, now that it runs you can drive it to the junkyard!”
low&slo ka24 is offline   Reply With Quote