View Single Post
Old 08-10-2015, 05:53 AM   #91
LURK3R's Avatar
Join Date: May 2013
Location: Bendigo, Victoria, Australia
Posts: 126
Vehicle: D21 Hardbody '89
Thanks: 10
Thanked 9 Times in 8 Posts

Ok I have the ECM out of the truck that I pulled the dash out of. I know which pin off the ECM goes to the tach, but where does the ECM get tach signal, I can't see that in the diagrams. It only shows that it goes from something to a 2.2kohm resistor, then the ECM, then the cluster. Will the ECM also need power. I'm wondering if I need to open a new thread. Late model cluster to Carb Z24.

'89 Nissan Navara
Static 5 inches lowered
Z24 Carb

LURK3R is offline   Reply With Quote