View Single Post
Old 05-23-2017, 03:28 AM   #3
Tilitdyze87
 
Join Date: May 2017
Location: Saskatoon
Posts: 9
Vehicle: 1987 Nissan D21 Kingcab
Thanks: 2
Thanked 0 Times in 0 Posts
Default

Thanks for getting back to me
I know you are right on the u-joint as I've checked this out too. I'm just wondering if the companion flange that mates the short shaft to the long shaft is interchangeable with latter years such as '88-'93. My theory is that since the center bearing has the same 30mm inner diameter through basically most model years, then the flanges should be interchangeable as well. This way I could take my '87 flange and mate it to the short shaft of the '88-'93 years which seem to be easier to find. I'm just wondering if anyone has encountered to same scenario and had success interchanging the flange before I go out and find one and try it. Thanks for your info though
Tilitdyze87 is offline   Reply With Quote