View Single Post
Old 04-21-2013, 01:22 AM   #18
Tally HB
The Old Guy
 
Join Date: Feb 2013
Location: North Florida
Age: 55
Posts: 721
Vehicle: 1989 D21 Base 2WD 2.4L
Thanks: 23
Thanked 94 Times in 78 Posts
Default

We can now install our rotor/wheel hub assembly. Simply slide the hub back onto the spindle and seat the rear seal.

Put the outer bearing back into hub, slide the retainer washer on, spin the pre-load nut on the spindle and do the proper tightening sequence.






































The caliper bracket is now ready to be installed.

Simply put it in place and install the bolts to the bracket. Notice there is one bolt longer than the other. They must be this way or it wont install correctly.

Long bolt at top, shorter bolt at bottom. These bolts need to be good and tight. Very tight.






Install the anti-rattle clips to the upper and lower bracket slider.




__________________
1989 D21 Standard Cab 4x2
2.4L Z24i, 5spd

Last edited by Tally HB; 04-21-2013 at 02:28 AM.
Tally HB is offline   Reply With Quote
Thanked by:
purp95hb (01-08-2014)