Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 94
Search took 1.54 seconds.
Search: Posts Made By: rare70cat
Forum: Im Looking For . . . 08-01-2018, 10:09 PM
Replies: 2
Views: 193
Posted By rare70cat
Found one

Thanks everyone looking but I found one.
Forum: Im Looking For . . . 07-30-2018, 07:21 PM
Replies: 2
Views: 193
Posted By rare70cat
86-89 auto trans extension housing

Looking for an automatic transmission extension housing from a '86-'89 d21.Trans bolts up to Z24 8 plug engine. Had my son's auto trans rebuilt but the extension housing is wore out so the bushing...
Forum: Hardbody Forum (D21) 05-31-2018, 12:40 PM
Replies: 11
Views: 458
Posted By rare70cat
I have put that tire on 3 Nissans. Love the tire!...

I have put that tire on 3 Nissans. Love the tire! I think 840 treadwear. Always quiet as it wears.The 1st set I put on my sandblasted and repainted steelies and had over 75k before buying pathfinder...
Forum: Wiring and Electrical 05-06-2018, 04:23 PM
Replies: 8
Views: 384
Posted By rare70cat
I got the same scenario after power washing the...

I got the same scenario after power washing the engine on Fri. Hope it dries out and goes away. The alternator isn't that old.
Forum: For Sale or Trade 05-06-2018, 04:12 PM
Replies: 46
Views: 2,209
Posted By rare70cat
I wrecked my 87 regular cab and found a beautiful...

I wrecked my 87 regular cab and found a beautiful 87 KC with a blown engine ($700) and swapped the entire drivetrain, entire wire harness and speedometer head to the 87KC and gave it to my son. I'm...
Forum: Hardbody Forum (D21) 09-13-2017, 11:01 PM
Replies: 12
Views: 745
Posted By rare70cat
Take a dremel tool and a round cutting wheel and...

Take a dremel tool and a round cutting wheel and cut a slot into the top of the bolt head. Then use a flat head screwdriver to remove the bolts. I had a problem with my ignition switch/column being...
Forum: Hardbody Forum (D21) 09-06-2017, 12:23 PM
Replies: 5
Views: 492
Posted By rare70cat
Oh I just remembered. I bought a '97 for the...

Oh I just remembered. I bought a '97 for the hf41, auto and parts(everything stock,tires etc). When I drove this truck at 60mph the truck's rpm gauge read like 2400rpms. To compare, my '96 with the...
Forum: Hardbody Forum (D21) 09-06-2017, 01:16 AM
Replies: 5
Views: 492
Posted By rare70cat
go figure

So I have a 96kc with an auto.It had a hf41 rear(4:11) I was getting 21mpg. So I change out the rear to a hf37 rear(3:70) thinking I was going to get better gas mileage. Turns out my mpg's got...
Forum: Wiring and Electrical 03-05-2017, 09:46 PM
Replies: 6
Views: 742
Posted By rare70cat
Driver side headlight just comes on!

On my son's '87, I noticed the driver side headlight had just come on. No key in the ignition. Just walked out and saw the one headlight on. Flipped the lever and it went out. Took the switch out and...
Forum: Hardbody Forum (D21) 03-05-2017, 09:40 PM
Replies: 15
Views: 1,422
Posted By rare70cat
I took a dremal tool and cut a enough of a slot...

I took a dremal tool and cut a enough of a slot to get them out. Then cut the slot longer and a little deeper. Put some blue loctite on the bolts and put them back in. No more movement. Thanks
Forum: Hardbody Forum (D21) 03-05-2017, 07:58 PM
Replies: 15
Views: 1,422
Posted By rare70cat
loose ignition switch collar

How do you tighten up the ignition switch collar? Mine moves back and forth when you insert the key. Looking under the collar it looks like some sort of pin and not a nut. Thanks
Forum: Im Looking For . . . 02-21-2017, 11:01 PM
Replies: 3
Views: 454
Posted By rare70cat
hardbody rea speaker mounts

looking for hardbody rear speaker mounts. Price? thanks
Forum: Hardbody Forum (D21) 09-21-2016, 12:19 PM
Replies: 7
Views: 684
Posted By rare70cat
I just replaced the fusible links like last...

I just replaced the fusible links like last Friday.lol but who knows....I'll check em again...lol
Forum: Hardbody Forum (D21) 09-21-2016, 03:06 AM
Replies: 7
Views: 684
Posted By rare70cat
Thanks dude. I'm reading in the FSM and this is...

Thanks dude. I'm reading in the FSM and this is what it says" Power transistor & ignition coil" The ignition signal from the ECU is amplified by the power transistor,which turns the ignition coil...
Forum: Hardbody Forum (D21) 09-21-2016, 02:25 AM
Replies: 7
Views: 684
Posted By rare70cat
I think I read the chart wrong. Ignition switch...

I think I read the chart wrong. Ignition switch 21 code is for 86 z24. The other tab has '87-'89 z24,v6. code 21 on that tab says "ignition signal missing in primary coil". The coils are pretty new....
Forum: Hardbody Forum (D21) 09-21-2016, 12:33 AM
Replies: 7
Views: 684
Posted By rare70cat
I just checked the codes. Got a 21 which says...

I just checked the codes. Got a 21 which says ignition switch. The keyed ignition switch was getting tough to turn and I sprayed some lube into the key hole. I wonder if I created my own problem?
Forum: Hardbody Forum (D21) 09-20-2016, 10:51 PM
Replies: 7
Views: 684
Posted By rare70cat
intermittent no tach and stumble acclerating

Today I started having an intermittent problem with my '87 Z24 auto. Truck started fine this a.m. Went to jump into some traffic and the Tach bounced around and the truck started stumbling. the tach...
Forum: Hardbody Forum (D21) 09-16-2016, 08:31 PM
Replies: 36
Sticky: Fusible links
Views: 24,178
Posted By rare70cat
These are the fusible links for '86-'89 hardbody...

These are the fusible links for '86-'89 hardbody with the Z24 engine. Part # are correct in previous post.
Forum: Hardbody Forum (D21) 09-15-2016, 06:47 AM
Replies: 36
Sticky: Fusible links
Views: 24,178
Posted By rare70cat
I believe I found the part # on nissanpartsdeal....

I believe I found the part # on nissanpartsdeal. I put in my VIN# and found the two fusible links. One part# is definitely 24022-01G05. The second part # is 24022-05E00. We'll see. I'm going to order...
Forum: Hardbody Forum (D21) 09-15-2016, 06:40 AM
Replies: 36
Sticky: Fusible links
Views: 24,178
Posted By rare70cat
That link is for a '95. Notice the so called...

That link is for a '95. Notice the so called "brown wires" that are actually pink,in that fusible link there are only 3 wires. Mine has four. Also the picture shows a second link that has two wires...
Forum: Hardbody Forum (D21) 09-15-2016, 01:30 AM
Replies: 36
Sticky: Fusible links
Views: 24,178
Posted By rare70cat
In the 1st picture provided, the black connector,...

In the 1st picture provided, the black connector, 24343, has two slots for two fusible links. One fusible link is 24022-01G05 that has the four wires. What is the part number for the other/2nd...
Forum: Engine and Drivetrain 08-23-2016, 09:42 PM
Replies: 31
Views: 2,692
Posted By rare70cat
I just replaced everything from the cat back. Got...

I just replaced everything from the cat back. Got the cat from rockauto. Stock walker unit. Got the stock walker replacement intermediate pipe and got the stainless muffler and tailpipe. Everything...
Forum: Im Looking For . . . 08-18-2016, 08:02 PM
Replies: 3
Views: 733
Posted By rare70cat
Sold. Thanks

Sold. Thanks
Forum: Hardbody Forum (D21) 08-16-2016, 09:51 PM
Replies: 26
Views: 2,960
Posted By rare70cat
I found this. Lots a BLING! ...

I found this. Lots a BLING! http://www.weapon-r.com/index.php?act=view_product&id=862. Look at the "product manual" it shows pics installed.
Forum: Im Looking For . . . 08-14-2016, 01:05 AM
Replies: 3
Views: 733
Posted By rare70cat
Your in LUCK! I just pulled my HF41 from my...

Your in LUCK! I just pulled my HF41 from my '96KC,KA24 with auto and 95k miles. I had a HF37 from another truck and swapped them for better gas mileage. I was getting 21mpg with stock rims and stock...
Showing results 1 to 25 of 94

 
Forum Jump

All times are GMT. The time now is 12:29 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.