Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 60
Search took 0.00 seconds.
Search: Posts Made By: jmaggot915
Forum: Engine and Drivetrain 12-01-2021, 03:03 AM
Replies: 1
Views: 46
Posted By jmaggot915
idle problems

I removed the throttle body to replace gaskets and give it a good cleaning. I also cleaned the idle control valve. Now I am having problems with high idle. Went off the the service manual now i can...
Forum: Nissan SUV 10-10-2021, 07:16 PM
Replies: 3
Views: 94
Posted By jmaggot915
99 pathfinder

99 pathfinder
Forum: Nissan SUV 10-04-2021, 04:03 AM
Replies: 3
Views: 94
Posted By jmaggot915
A/C control module

Need to replace ac control module. But have no idea how to remove the cables attached to the module that control the vent doors or even how to pull out the module. I have taken off the screws that...
Forum: Exterior & Paint and Body 08-09-2021, 12:23 AM
Replies: 4
Views: 106
Posted By jmaggot915
Inner fender help

Do i need the inner fender cover to avoid the tire rubbing. Or what options would i have i bought 4x4 fenders with the inner covers not sure if i need the or just trim to avoid rubbing. Any help will...
Forum: Nissan SUV 08-02-2021, 02:36 AM
Replies: 1
Views: 72
Posted By jmaggot915
99 path dash lights

My dash lights on my 99 pathfinder turn on when ignition key is turned. Then when i turn the headlights on the dash lights turn off. Any ideas that could point me in the right direction. Thanks in...
Forum: Suspension 07-21-2021, 05:16 AM
Replies: 2
Views: 155
Posted By jmaggot915
front lowering help!

I lowered my truck with the torsion bars. Got some d21 4x4 front shocks and changed out the bump stops for some energy suspension bump stop. Now it is scraping the wheel well need to be careful of...
Forum: Suspension 05-16-2021, 08:09 PM
Replies: 1
Views: 165
Posted By jmaggot915
shocks

Are the front shocks different between 2wd and 4wd. Wondering for static front drop through the torsion bar. Not trying to go to the ground just a nice drop nothing crazy this is my daily. Thanks for...
Forum: Engine and Drivetrain 04-25-2021, 02:59 AM
Replies: 3
Views: 167
Posted By jmaggot915
fuel economy

Maybe this is a dumb question. I changed my thermostat on my truck but I got a 180 degree thermostat instead of a 170. Would that mess with how much fuel it uses. Prior to the change and same kind of...
Forum: Interior & Audio/Video 02-24-2021, 11:32 PM
Replies: 10
Views: 545
Posted By jmaggot915
Roof Handle

If my truck came without roof handles. Am i able to install them or do I need to do something special to install them. Thanks for any info.
Forum: Hardbody Forum (D21) 02-14-2021, 01:32 AM
Replies: 3
Views: 139
Posted By jmaggot915
Battery ground

When removing my power steering pump found a loose battery ground bolt. As i went to tighten it a bit then found out that i could just pull it out with no problem. Is there another location i could...
Forum: Suspension 05-26-2020, 06:28 AM
Replies: 6
Views: 462
Posted By jmaggot915
Its 3 inch with a 2 degree taper according to the...

Its 3 inch with a 2 degree taper according to the belltech web site part #6202. The bottom part goes into the leaf spring but then the top nipple part doesnt line up with axel.
Forum: Suspension 05-26-2020, 03:38 AM
Replies: 6
Views: 462
Posted By jmaggot915
The belltech lowering blocks that i got don't...

The belltech lowering blocks that i got don't seem to line up I'm wonder if I'm doing something wrong. According to the belltech website their the right part number. Any help will be appreciated.
Forum: Suspension 05-25-2020, 07:56 PM
Replies: 6
Views: 462
Posted By jmaggot915
Thanks Alabama appreciated. Can I use the oem...

Thanks Alabama appreciated. Can I use the oem shocks or do I need to change them at the same time.
Forum: Suspension 05-25-2020, 02:26 AM
Replies: 6
Views: 462
Posted By jmaggot915
leaf spring removal

I have been trying to figure out how to remove leaf spring. Going to replace bushings and put in a 3 inch lowering block. Do I lift the rear on jacks then unbolt u bolts then jack axel to take weight...
Forum: Engine and Drivetrain 08-15-2019, 01:05 AM
Replies: 2
Views: 142
Posted By jmaggot915
engine swap

which engine would be the best and some what easiest to swap out. currently have a ka24e 4 cylinder. thanks for any help.
Forum: Engine and Drivetrain 06-02-2019, 10:58 PM
Replies: 5
Views: 290
Posted By jmaggot915
motor mounts

How do i diagnose if motor mounts need to be replaced. When i rev engine it twist towards the passenger side not a lot but enough to make me worry. Would bad motor mounts cause engine to shutter and...
Forum: Engine and Drivetrain 01-05-2019, 03:22 AM
Replies: 12
Views: 1,011
Posted By jmaggot915
Transmission ?

My truck D21 automatic 4 cylinder made a loud whistling noise. Then all of a sudden no gears in any position. Any ideas before i have to go into major repairs. Thanks for any info.
Forum: Suspension 07-17-2018, 08:15 PM
Replies: 8
Views: 683
Posted By jmaggot915
Wouldn't I be riding on the bump stop if I loosen...

Wouldn't I be riding on the bump stop if I loosen the torsion bar. If that's ok good one less thing to modify. Thanks
Forum: Suspension 07-16-2018, 10:09 PM
Replies: 8
Views: 683
Posted By jmaggot915
Torsion bar ?

Planning on lowering my truck via torsion bar. Should I still use the stock bump stop or should I get a shorter bump stop and reload torsion bar from shorter bump stop. Thanks for any info.
Forum: Wiring and Electrical 06-04-2018, 08:11 PM
Replies: 3
Views: 469
Posted By jmaggot915
headlight switch

My truck battery died over the weekend. The culprit was one of the lights was on overnight. I just jiggled the handle and the headlight went out. Can it be fixed or is it something I have to replace....
Forum: Nissan SUV 03-25-2018, 01:39 AM
Replies: 3
Views: 1,385
Posted By jmaggot915
changed struts

I changed to front struts on my 2wd 99 pathfinder. I noticed that the front is slightly higher than the rear. Will it after a while will it settle down a bit. I did not replace the rear shocks yet...
Forum: Exterior & Paint and Body 03-14-2018, 01:17 AM
Replies: 10
Views: 1,709
Posted By jmaggot915
Fender flares

Looking for some fender flares for my 92 d21 or ideas of other kind of flares that would good. Thanks in advance.
Forum: Engine and Drivetrain 10-07-2017, 02:45 AM
Replies: 0
Ecu
Views: 373
Posted By jmaggot915
Ecu

Has anyone used a 14 pin to 16 pin adapter for obd scanning. If so did you use a regular scanner or would an app adapter work. Thanks for any info.
Forum: Engine and Drivetrain 07-12-2017, 09:16 PM
Replies: 2
Views: 593
Posted By jmaggot915
Throttle cable

Need to know how much slack should the throttle cable have. Repair manual did not say how much. Any help will be appreciated.
Forum: Wiring and Electrical 05-12-2017, 09:44 PM
Replies: 10
Views: 1,370
Posted By jmaggot915
Correct

Correct
Showing results 1 to 25 of 60

 
Forum Jump

All times are GMT. The time now is 12:12 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.