Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.18 seconds.
Search: Posts Made By: alabama_lowlife
Forum: Hardbody Forum (D21) 09-20-2018, 01:15 AM
Replies: 9
Views: 115
Posted By alabama_lowlife
Disconnect the sensor and check for 5 Vdc between...

Disconnect the sensor and check for 5 Vdc between the 2 wires with the key on. Check the resistance of the sensor. At 20 degrees C it should read 2.1k-2.9k ohms. At 50 degrees C it should read...
Forum: Wiring and Electrical 09-19-2018, 01:55 AM
Replies: 4
Views: 48
Posted By alabama_lowlife
Welcome to infamous Nissan! Usually the...

Welcome to infamous Nissan! Usually the speedometer cable breaks at the cluster end of the cable.
Forum: Introductions 09-19-2018, 12:04 AM
Replies: 5
Views: 47
Posted By alabama_lowlife
Welcome to infamous Nissan

Welcome to infamous Nissan
Forum: Hardbody Forum (D21) 09-18-2018, 05:48 PM
Replies: 8
Views: 82
Posted By alabama_lowlife
Not that I’ve heard anybody mention. I just...

Not that I’ve heard anybody mention. I just soldered the wires back to the sensor.
Forum: Hardbody Forum (D21) 09-18-2018, 01:45 PM
Replies: 8
Views: 82
Posted By alabama_lowlife
Yeah, they break easily

Yeah, they break easily
Forum: Project Build Log 09-18-2018, 09:54 AM
Replies: 49
Views: 8,761
Posted By alabama_lowlife
Loving this one so far

Loving this one so far
Forum: Introductions 09-18-2018, 09:52 AM
Replies: 4
Views: 30
Posted By alabama_lowlife
Welcome to infamous nissan

Welcome to infamous nissan
Forum: Hardbody Forum (D21) 09-18-2018, 12:47 AM
Replies: 15
Views: 187
Posted By alabama_lowlife
A compression test would likely tell you if the...

A compression test would likely tell you if the head gasket is blown
Forum: Introductions 09-17-2018, 09:49 AM
Replies: 3
Views: 26
Posted By alabama_lowlife
I would clean the lines out with some alcohol or...

I would clean the lines out with some alcohol or something like that and some compressed air.
Forum: Hardbody Forum (D21) 09-17-2018, 01:45 AM
Replies: 15
Views: 187
Posted By alabama_lowlife
If it takes a long time to reach operating...

If it takes a long time to reach operating temperature your thermostat is probably stuck open. I would only use a genuine Nissan thermostat. I’ve had bad luck with aftermarket thermostats.

Beyond...
Forum: Engine and Drivetrain 09-16-2018, 09:31 PM
Replies: 7
Views: 80
Posted By alabama_lowlife
As far as the aluminum, really you have 2...

As far as the aluminum, really you have 2 choices. Rebuild it, or let it ride and hope for the best. I’d let it ride and change the oil on some short intervals a couple of times.
Forum: Hardbody Forum (D21) 09-16-2018, 02:25 PM
Replies: 40
Views: 307
Posted By alabama_lowlife
Like the teeth in your mouth?

Like the teeth in your mouth?
Forum: Hardbody Forum (D21) 09-16-2018, 02:24 PM
Replies: 9
Views: 115
Posted By alabama_lowlife
Stalling when it warms up makes me think about...

Stalling when it warms up makes me think about the coolant temperature sensor. Especially when combined with excess fuel. Pull the codes on your computer to see if it is flagging anything.

Also,...
Forum: Wiring and Electrical 09-15-2018, 12:33 AM
Replies: 3
Views: 53
Posted By alabama_lowlife
Check that radio wiring and the dimmer.

Check that radio wiring and the dimmer.
Forum: Project Build Log 09-14-2018, 10:06 AM
Replies: 36
Views: 3,586
Posted By alabama_lowlife
Looking good man

Looking good man
Forum: Hardbody Forum (D21) 09-14-2018, 12:50 AM
Replies: 17,984
Views: 1,304,273
Posted By alabama_lowlife
One pic? That’s just wrong! You can’t tease...

One pic? That’s just wrong! You can’t tease people like that lol
Forum: Project Build Log 09-13-2018, 11:14 PM
Replies: 16
Views: 524
Posted By alabama_lowlife
That’s nice

That’s nice
Forum: General Discussion 09-13-2018, 03:14 PM
Replies: 9
Views: 68
Posted By alabama_lowlife
They have a short pigtail coming off the back...

They have a short pigtail coming off the back that has a 3 prong plug to connect to the factory wiring.
Forum: General Discussion 09-13-2018, 03:13 PM
Replies: 9
Views: 68
Posted By alabama_lowlife
https://youtu.be/n5Uie_vtSgE

https://youtu.be/n5Uie_vtSgE
Forum: General Discussion 09-13-2018, 03:11 PM
Replies: 9
Views: 68
Posted By alabama_lowlife
I just bought these from amazon. On FoulMouth’s...

I just bought these from amazon. On FoulMouth’s YouTube channel he did a review on them so I figured I’d give them a try. I had some nice Hella H4 housings so my son used them with the new bulbs and...
Forum: Introductions 09-11-2018, 12:58 AM
Replies: 3
Views: 55
Posted By alabama_lowlife
Welcome to infamous nissan

Welcome to infamous nissan
Forum: Introductions 09-11-2018, 12:51 AM
Replies: 7
Views: 112
Posted By alabama_lowlife
There are still very nice trucks out there for...

There are still very nice trucks out there for sale. It just depends on what you’re looking for and what your budget is.
Forum: Introductions 09-08-2018, 09:24 PM
Replies: 6
Views: 68
Posted By alabama_lowlife
Welcome to infamous Nissan!

Welcome to infamous Nissan!
Forum: Hardbody Forum (D21) 09-08-2018, 09:08 PM
Replies: 17,984
Views: 1,304,273
Posted By alabama_lowlife
Sunday I had my wife order me 4 yards of grey...

Sunday I had my wife order me 4 yards of grey headliner material off eBay because I found a listing that had 4 yards for $9. It came in today. One FOOT of headliner material. One. Fucking. Foot. I...
Forum: Introductions 09-08-2018, 01:14 PM
Replies: 5
Views: 74
Posted By alabama_lowlife
Welcome to infamous nissan

Welcome to infamous nissan
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 01:22 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.