Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.20 seconds.
Search: Posts Made By: alabama_lowlife
Forum: Wheels and Tires Today, 12:41 AM
Replies: 2
Views: 19
Posted By alabama_lowlife
Moved to the wheels and tires forum and stuck.

Moved to the wheels and tires forum and stuck.
Forum: Im Looking For . . . Yesterday, 07:17 PM
Replies: 14
Views: 106
Posted By alabama_lowlife
The truck is long gone and I couldn’t find any...

The truck is long gone and I couldn’t find any pics of them in the truck.
Forum: Im Looking For . . . Yesterday, 04:11 AM
Replies: 14
Views: 106
Posted By alabama_lowlife
I used some 01-04 frontier floor mats in my 97....

I used some 01-04 frontier floor mats in my 97. They aren’t a perfect fit but they fit well enough that they didn’t look out of place. Much better than an aftermarket mat.
Forum: Engine and Drivetrain Yesterday, 04:08 AM
Replies: 12
Views: 87
Posted By alabama_lowlife
What oil weight are you using? Nissan calls for...

What oil weight are you using? Nissan calls for 5w30. You may have to pull the lash adjusters and give them a good cleaning to rehab them. I was always hesitant to try this on my 97 that occasionally...
Forum: Hardbody Forum (D21) 12-08-2018, 02:17 AM
Replies: 18,516
Views: 1,350,946
Posted By alabama_lowlife
Where did you get the thermostat?

Where did you get the thermostat?
Forum: Introductions 12-07-2018, 01:51 AM
Replies: 16
Views: 114
Posted By alabama_lowlife
Welcome to infamous Nissan!

Welcome to infamous Nissan!
Forum: Hardbody Forum (D21) 12-06-2018, 11:57 PM
Replies: 4
Views: 56
Posted By alabama_lowlife
Get the valve stem seals while you’re in there. I...

Get the valve stem seals while you’re in there. I wouldn’t bother with rings unless you know compression is low.
Forum: Wiring and Electrical 12-06-2018, 02:56 PM
Replies: 1
Views: 30
Posted By alabama_lowlife
Those are a lot of weird little issues. I’d pull...

Those are a lot of weird little issues. I’d pull the cluster out to check the bulbs and replace them if needed. Then clean the contact points between the bulbs and the cluster and the wiring harness...
Forum: Hardbody Forum (D21) 12-04-2018, 10:40 AM
Replies: 6
Views: 99
Posted By alabama_lowlife
Nice truck! I don’t recall my Z24 having anywhere...

Nice truck! I don’t recall my Z24 having anywhere near as many issues as an of the KA’s I’ve had. I wasn’t nearly as mechanically inclined in my younger days as I am now so I would remember serious...
Forum: Project Build Log 12-03-2018, 02:13 AM
Replies: 9
Views: 710
Posted By alabama_lowlife
Looking good man

Looking good man
Forum: Engine and Drivetrain 12-03-2018, 02:09 AM
Replies: 12
Views: 87
Posted By alabama_lowlife
Without a timing light, the spark could be firing...

Without a timing light, the spark could be firing as much as 15 degrees off. That can/will make the engine noisy as well. Get a battery, let the truck warm up, disconnect the TPS, and set the timing...
Forum: Wiring and Electrical 12-03-2018, 01:37 AM
Replies: 3
Views: 61
Posted By alabama_lowlife
Vehicles do weird shit when the alternator isn’t...

Vehicles do weird shit when the alternator isn’t charging correctly and the battery is dying. My wife’s 300zx was skipping for 15-20 miles before I realized the alternator was going. If you know you...
Forum: Engine and Drivetrain 12-03-2018, 01:31 AM
Replies: 12
Views: 87
Posted By alabama_lowlife
How long did the truck sit without running while...

How long did the truck sit without running while you did the work? If it was down a while it may be taking a while to bleed the air out of the lifters. Have you set the timing to 10 degrees BTDC with...
Forum: Wiring and Electrical 12-02-2018, 04:49 PM
Replies: 3
Views: 61
Posted By alabama_lowlife
Sounds like the alternator is failing to start...

Sounds like the alternator is failing to start with. The low battery light should never be illuminated while the truck is running.
Forum: Engine and Drivetrain 12-02-2018, 04:44 PM
Replies: 12
Views: 87
Posted By alabama_lowlife
If you don’t KNOW that you have the timing set...

If you don’t KNOW that you have the timing set correctly, then you have the timing set incorrectly. The chances of you getting it right by accident are virtually impossible.
Forum: Photography 12-02-2018, 04:41 PM
Replies: 1
Views: 41
Posted By alabama_lowlife
I haven’t seen that episode but I’m sure I’ll...

I haven’t seen that episode but I’m sure I’ll catch it sooner or later
Forum: General Discussion 12-02-2018, 04:40 PM
Replies: 4
Views: 79
Posted By alabama_lowlife
I think that’s probably a scam website. I’ve seen...

I think that’s probably a scam website. I’ve seen stuff about those devices and supposedly they are very expensive.
Forum: Suspension 12-02-2018, 04:50 AM
Replies: 3
Views: 66
Posted By alabama_lowlife
Have a look at the rear end of the torsion bars,...

Have a look at the rear end of the torsion bars, where the anchors are. Also, the steering stops have plastic caps on them that will often break and make noises when turned to full lock. Check those...
Forum: For Sale or Trade 12-01-2018, 09:56 PM
Replies: 2
Views: 76
Posted By alabama_lowlife
If you’ll select the “go advanced” button, select...

If you’ll select the “go advanced” button, select “manage attachments” you can upload pictures to attach to your post.
Forum: Hardbody Forum (D21) 12-01-2018, 07:05 PM
Replies: 37
Views: 392
Posted By alabama_lowlife
PaineTrain’s low price is an anomaly. Usually...

PaineTrain’s low price is an anomaly. Usually 4x4’s with low mileage and good condition cost a lot more than he paid. He got a damn good deal on his truck.
Forum: Hardbody Forum (D21) 12-01-2018, 03:52 AM
Replies: 18,516
Views: 1,350,946
Posted By alabama_lowlife
They’re the same engine. I would recommend new...

They’re the same engine. I would recommend new gaskets everywhere before you install it.
Forum: Hardbody Forum (D21) 11-27-2018, 04:25 PM
Replies: 18,516
Views: 1,350,946
Posted By alabama_lowlife
Rock sliders look so much cooler than nerf bars...

Rock sliders look so much cooler than nerf bars did.
Forum: Hardbody Forum (D21) 11-26-2018, 11:09 AM
Replies: 23
Views: 560
Posted By alabama_lowlife
Based on this picture, specifically the area I...

Based on this picture, specifically the area I have circled, I’d be willing to bet money that your chain has cut into the timing cover. Additionally, the severity in which the engine is coated with...
Forum: Hardbody Forum (D21) 11-26-2018, 10:48 AM
Replies: 170
Views: 3,092
Posted By alabama_lowlife
Start by removing the valve cover and looking...

Start by removing the valve cover and looking over the rockers and valves to see if there is any obvious damage.
Forum: Interior & Audio/Video 11-25-2018, 02:16 PM
Replies: 8
Views: 214
Posted By alabama_lowlife
There may have been an option in some years where...

There may have been an option in some years where there were rear speakers in a regular cab, but I’ve not seen any myself. As a general rule, it’s safe to say they didn’t have them. And any that did...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 12:46 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.