Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 7 of 7
Search took 0.00 seconds.
Search: Posts Made By: Framebender
Forum: Hardbody Forum (D21) 05-03-2018, 10:07 PM
Replies: 10
Views: 291
Posted By Framebender
Ok so I found the noise before I pulled the...

Ok so I found the noise before I pulled the engine. Turns out when i meshed the engine and trans something with the clutch was hitting. My neighbor says throw out bearing wasn't seating right. It...
Forum: Hardbody Forum (D21) 05-02-2018, 06:18 AM
Replies: 10
Views: 291
Posted By Framebender
The engine had a slight knock so i rebuilt it....

The engine had a slight knock so i rebuilt it. New bearings, pistons, oil pump all the goodies. On the initial start up there was some noise but most of it went away as soon as oil pressure built up....
Forum: Hardbody Forum (D21) 05-02-2018, 03:37 AM
Replies: 10
Views: 291
Posted By Framebender
I guess I have to pull the motor then and tear it...

I guess I have to pull the motor then and tear it down.
Forum: Hardbody Forum (D21) 05-02-2018, 12:14 AM
Replies: 10
Views: 291
Posted By Framebender
Timing chain too tight?

I just finished a rebuild on my 90 d21 ka24e. The engine has a knockwitrh fresh bearings in it. When I put the timing set on I noticed the timing chain was tight without the pin pulled on the...
Forum: Engine and Drivetrain 05-02-2018, 12:10 AM
Replies: 1
Views: 119
Posted By Framebender
Timing Issue(Need help)

So I pulled my engine and did a rebuild on it. When I got to the timing set I noticed the chain was really tight without the pin pulled on the tensioner. Is this normal? When I started the engine...
Forum: Suspension 03-16-2018, 09:43 PM
Replies: 2
Views: 250
Posted By Framebender
The tie rods all fit into the link but the link...

The tie rods all fit into the link but the link doesnt fit into the pitman arm that great. Is the drag link supposed to have one side that acts like a ball joint and one side thats supposed to swivel...
Forum: Suspension 03-16-2018, 06:08 PM
Replies: 2
Views: 250
Posted By Framebender
Drag link problem

I replaced the drag link and tie rods with a cheap ebay kit. The idler arm made the tie rod on the passenger side rub the frame that the lower control arm connects to so I had to reuse the old one....
Showing results 1 to 7 of 7

 
Forum Jump

All times are GMT. The time now is 03:56 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.