Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: mdhanner
Forum: Hardbody Forum (D21) 01-21-2022, 05:49 PM
Replies: 10
Views: 82
Posted By mdhanner
The o-ring is around outside of the injector it...

The o-ring is around outside of the injector it seals the injector into the TB cavity. I'm starting to wonder if the timing is slow. Sounds bit labored idling and seems low on power. I loaned it to...
Forum: Hardbody Forum (D21) 01-20-2022, 02:19 PM
Replies: 10
Views: 82
Posted By mdhanner
As far as the injector resealed ordered a reseal...

As far as the injector resealed ordered a reseal kit two o-rings and filter. Pull injector replace o-rings..
Forum: Hardbody Forum (D21) 01-20-2022, 02:16 PM
Replies: 10
Views: 82
Posted By mdhanner
I'm planning on pulling codes but it's 9degrees...

I'm planning on pulling codes but it's 9degrees out this morning. Warmer tomorrow my shop is full with two pallets of concrete..
I had codes for Maf replaced that for running bad at idle hard...
Forum: Hardbody Forum (D21) 01-20-2022, 12:13 AM
Replies: 10
Views: 82
Posted By mdhanner
Thank you .. once it warms up to at least 40 out...

Thank you .. once it warms up to at least 40 out I'll take some. I also have a 91 multi port injection it's at 201,000 but my everyday driver
Forum: Hardbody Forum (D21) 01-20-2022, 12:00 AM
Replies: 10
Views: 82
Posted By mdhanner
No start cold starts fine above 30 degrees 89 d21 2.4

My D21 was flooding found bad pressure regulator found good used one in salvage replaced it runs much better but doesn't start cold. Will backfire slightly out exhaust with closed throttle just...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT. The time now is 09:26 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.