Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.12 seconds.
Search: Posts Made By: OldGreyBeast
Forum: Hardbody Forum (D21) 09-19-2018, 07:39 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
The lift range is what kept me from getting some...

The lift range is what kept me from getting some of those. The only car it would work on for me is my old 190D. The others are either too low or too high, lol.
Forum: Wiring and Electrical 09-19-2018, 02:36 PM
Replies: 4
Views: 49
Posted By OldGreyBeast
If your speedo still doesn't work properly after...

If your speedo still doesn't work properly after swapping the cable, it's possible your speedo head has gone wonky. Usually replacing the cable does the trick. They aren't too expensive and it's...
Forum: Hardbody Forum (D21) 09-18-2018, 05:36 PM
Replies: 15
Views: 187
Posted By OldGreyBeast
Mine was blown between cylinders on the left...

Mine was blown between cylinders on the left (driver's) side and a whole hunk was missing around a coolant/oil passage on the passenger side. One cylinder pretty much didn't work because of...
Forum: Hardbody Forum (D21) 09-18-2018, 04:27 PM
Replies: 15
Views: 187
Posted By OldGreyBeast
I drove my truck with both head gaskets blown for...

I drove my truck with both head gaskets blown for a decent little while and it still ran fairly well other than the perpetual overheating.
Forum: The Other Forum 09-18-2018, 04:21 PM
Replies: 12
Views: 581
Posted By OldGreyBeast
Hope you like your Asus, they make good stuff. I...

Hope you like your Asus, they make good stuff. I bought one of their little netbooks (before tablets were a thing) to use during college in 2004. It still runs just fine.
Forum: Hardbody Forum (D21) 09-17-2018, 07:00 PM
Replies: 8
Views: 66
Posted By OldGreyBeast
When you say it has a hard time starting, does it...

When you say it has a hard time starting, does it sit there turning over for a long time before it fires, or does it sputter about after it fires acting like it's going to die?
Forum: Hardbody Forum (D21) 09-17-2018, 06:58 PM
Replies: 15
Views: 187
Posted By OldGreyBeast
Check all your grounds as well. My D21 had rough...

Check all your grounds as well. My D21 had rough idle, sputtering, occasional total power loss under accelleration, etc. It turned out to be a bad ground in the engine bay, I can't remember which...
Forum: General Discussion 09-17-2018, 04:52 PM
Replies: 954
Views: 59,281
Posted By OldGreyBeast
Picture of the Luger and part of the Carcano. ...

Picture of the Luger and part of the Carcano. Taken in the floor of the old 190d, my house carpet isn't that nasty lol.


https://i.imgur.com/OrhLvkeh.jpg
Forum: Hardbody Forum (D21) 09-17-2018, 04:50 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
Had to fix yet another coolant leak. This time...

Had to fix yet another coolant leak. This time one of the hoses on the throttle body had a slow leak. Tightened up the hose clamp, hopefully that fixes it. I replaced that hose about 5 or 6 years...
Forum: General Discussion 09-17-2018, 03:44 PM
Replies: 111
Views: 4,599
Posted By OldGreyBeast
Man, it varied WILDLY! The first shop I went to...

Man, it varied WILDLY! The first shop I went to quoted me 7k, if that's what I was looking at I was just going to LS swap the thing. The next one I went to quoted 4400. The 3rd shop (an...
Forum: General Discussion 09-13-2018, 03:26 PM
Replies: 954
Views: 59,281
Posted By OldGreyBeast
The Luger is all matching, it's a bit rusty and...

The Luger is all matching, it's a bit rusty and doesn't have the original finish unfortunately, but it shoots great. The Carcano has a bit of surface rust, appears to be original finish. Seems to...
Forum: General Discussion 09-13-2018, 01:51 PM
Replies: 17
Views: 1,430
Posted By OldGreyBeast
I had to abandon the previous method of setting...

I had to abandon the previous method of setting up the e-brake. The accessibility options of the Xbone aren't compatible with the wheel :(


Not one to give up, I took the wheel completely apart,...
Forum: General Discussion 09-13-2018, 01:35 PM
Replies: 111
Views: 4,599
Posted By OldGreyBeast
My 190D is at the transmission shop at the...

My 190D is at the transmission shop at the moment. He called yesterday and told me that the trans was worn clap out but should rebuild nicely. I can't wait to feel how it drives with a proper...
Forum: Project Build Log 09-13-2018, 01:33 PM
Replies: 729
Views: 134,351
Posted By OldGreyBeast
Dang I didn't realize it's been 2 years since...

Dang I didn't realize it's been 2 years since there's been progress on this guy. That's a long wait man!
Forum: General Discussion 09-13-2018, 01:31 PM
Replies: 954
Views: 59,281
Posted By OldGreyBeast
So.... here's one that's probably gonna make some...

So.... here's one that's probably gonna make some guys jealous. I picked up a pre-WWII DWM Luger 9mm and a war production Italian Carcano for $300 - not $300/ea, $300 for both together.


Once in...
Forum: Hardbody Forum (D21) 09-13-2018, 01:30 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
Still working on retrofitting the Frontier center...

Still working on retrofitting the Frontier center console into my truck. Removed the e-brake handle and made a block off plate for that hole in the floor to reduce noise. Haven't bought the...
Forum: Hardbody Forum (D21) 08-06-2018, 09:25 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
You play on PC? I'm jtb2468 on steam.

You play on PC? I'm jtb2468 on steam.
Forum: Hardbody Forum (D21) 08-06-2018, 08:40 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
57? those are rookie numbers :P

57? those are rookie numbers :P
Forum: Hardbody Forum (D21) 08-06-2018, 06:56 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
Yeah but unlike real life we don't get to pick,...

Yeah but unlike real life we don't get to pick, lol. I was born with no communications skills.
Forum: Hardbody Forum (D21) 08-06-2018, 06:50 PM
Replies: 37
Views: 647
Posted By OldGreyBeast
Jeez man... I had to have mine extended when I...

Jeez man... I had to have mine extended when I did the body lift later. Since they'd rebuilt them to begin with they extended them for cost of materials.
Forum: Hardbody Forum (D21) 08-06-2018, 06:47 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
Yes haha. I present to you a poorly photoshopped...

Yes haha. I present to you a poorly photoshopped tree of my skillz.


https://i.imgur.com/1iX5M4M.png
Forum: Hardbody Forum (D21) 08-06-2018, 06:33 PM
Replies: 37
Views: 647
Posted By OldGreyBeast
There's a local place here that rebuilds...

There's a local place here that rebuilds hoses/pipes/etc. I had them rebuild both of mine when I redid the AC in my truck back in '13 or so. It was less than a hundred bucks. If you don't have...
Forum: General Discussion 08-06-2018, 04:06 PM
Replies: 17
Views: 1,430
Posted By OldGreyBeast
Got the e-brake mounted and the controller setup...

Got the e-brake mounted and the controller setup so that the e-brake pushes the "b" button (for handbrake). Making use of the Xbox One's "Co-pilot" accessibility feature that allows 2 controllers to...
Forum: Hardbody Forum (D21) 08-06-2018, 01:44 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
Be thankful for what you get lol. I'm 31 and...

Be thankful for what you get lol. I'm 31 and still carrying the V card.


Man Portland must be a hotbed of D21 thefts. There's at least one other guy here (can't remember his name....seems like...
Forum: Hardbody Forum (D21) 08-03-2018, 02:46 PM
Replies: 17,995
Views: 1,305,033
Posted By OldGreyBeast
I got stressed out at work the other day. Started...

I got stressed out at work the other day. Started fiddling with the truck when I got home. Next thing I knew...


https://i.imgur.com/G10iF3Gh.jpg
Replacing the console with one from a early...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 12:53 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.