Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 53
Search took 0.01 seconds.
Search: Posts Made By: Emendia
Forum: General Discussion 08-27-2017, 03:55 AM
Replies: 959
Views: 60,494
Posted By Emendia
Well, I'm a middle aged lady! But I own a 20gauge...

Well, I'm a middle aged lady! But I own a 20gauge mossy (much nicer than a 12 gauge for me,) and a .22LR NEF revolver my godfather gave me.
Forum: Engine and Drivetrain 08-27-2017, 03:45 AM
Replies: 22
Views: 1,047
Posted By Emendia
OP. Saw in the other thread you got your fuel...

OP. Saw in the other thread you got your fuel pump installed and it all worked out for you - glad it all went well.
Forum: Hardbody Forum (D21) 08-27-2017, 03:41 AM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
Installed a new fuel pump. Next up, a bolt in...

Installed a new fuel pump. Next up, a bolt in muffler assembly.
Forum: Hardbody Forum (D21) 08-27-2017, 03:38 AM
Replies: 27
Views: 1,342
Posted By Emendia
Yep. Did it this morning. ...

Yep. Did it this morning.
http://www.infamousnissan.com/forum/picture.php?albumid=2848&pictureid=19339
Forum: Engine and Drivetrain 08-27-2017, 01:52 AM
Replies: 22
Views: 1,047
Posted By Emendia
All told it took around three hours. If it...

All told it took around three hours. If it weren't so damn hot it would have gone faster. Hope this helps the OP and others - it was actually a fun job, and the truck is running great. I still have...
Forum: Engine and Drivetrain 08-27-2017, 01:49 AM
Replies: 22
Views: 1,047
Posted By Emendia
Couldn't get the old pump out of its harness,...

Couldn't get the old pump out of its harness, which was crumbling apart anyway, so had to zip tie the new one in place. Cleaned the old assembly with a wire brush... hope this lasts a couple of...
Forum: Engine and Drivetrain 08-27-2017, 01:46 AM
Replies: 22
Views: 1,047
Posted By Emendia
Holy moly. The original assembly was crap and...

Holy moly. The original assembly was crap and falling apart. Should probably have pumped the tank cleaned it out, blown the lines with air, and replaced the fuel filter just in case!...
Forum: Engine and Drivetrain 08-27-2017, 01:43 AM
Replies: 22
Views: 1,047
Posted By Emendia
Bolts on top are 8mm and easy to remove. ...

Bolts on top are 8mm and easy to remove.

http://www.infamousnissan.com/forum/picture.php?albumid=2848&pictureid=19341
Forum: Engine and Drivetrain 08-27-2017, 01:39 AM
Replies: 22
Views: 1,047
Posted By Emendia
Plenty of clearance by tilting the bed... ...

Plenty of clearance by tilting the bed...

http://www.infamousnissan.com/forum/picture.php?albumid=2848&pictureid=19339
Forum: Engine and Drivetrain 08-25-2017, 05:38 PM
Replies: 22
Views: 1,047
Posted By Emendia
PS - Does anyone know if there are any special...

PS - Does anyone know if there are any special tools required for removing the pump? Looks like just it just screws in...
Forum: Engine and Drivetrain 08-25-2017, 05:37 PM
Replies: 22
Views: 1,047
Posted By Emendia
For what it's worth, here's the pump I got......

For what it's worth, here's the pump I got... these normally go for double. Bosch is, obviously, a reputable brand.
...
Forum: Engine and Drivetrain 08-25-2017, 05:34 PM
Replies: 22
Views: 1,047
Posted By Emendia
Hey, I'm about to replace the fuel pump on my 92....

Hey, I'm about to replace the fuel pump on my 92. I got a good deal on a Bosch fuel pump on Amazon. I'm replacing it because I can clearly hear it struggling when I turn the ignition to,on, and I...
Forum: Hardbody Forum (D21) 08-24-2017, 05:22 AM
Replies: 27
Views: 1,342
Posted By Emendia
You can also remove the gas cap and listen down...

You can also remove the gas cap and listen down the tube to hear if the pump is making noises. You said its intermittent... Sometimes you hear it pump when you turn the ignition to the on position,...
Forum: Hardbody Forum (D21) 08-24-2017, 03:24 AM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
Replaced my original MAF (that I stupidly broke...

Replaced my original MAF (that I stupidly broke the wires on) with a generic one from Amazon. I read that these generics may hurt your gas mileage, so when I have the dough I may get an OEM Hitachi.
Forum: Exterior & Paint and Body 08-22-2017, 02:44 AM
Replies: 4
Views: 692
Posted By Emendia
Wish I could... but I live in an apartment...

Wish I could... but I live in an apartment complex. They're so strict they don't allow any car repairs on the property, let alone some sort of makeshift spray booth... and living in Cali also means I...
Forum: General Discussion 08-22-2017, 02:40 AM
Replies: 72
Views: 5,360
Posted By Emendia
So despite my misgivings about LKQ, went today...

So despite my misgivings about LKQ, went today and got three small dash vents for my d21 for a buck a piece. A set of four sells on eBay for thirty bucks, so score one for LKQ!
Forum: Hardbody Forum (D21) 08-20-2017, 06:18 AM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
Truck looks clean! What did I do today? Diagnosed...

Truck looks clean! What did I do today? Diagnosed a bad fuel pump.... now to replace it when I have the cash.
Forum: General Discussion 08-10-2017, 05:05 AM
Replies: 72
Views: 5,360
Posted By Emendia
Not necessarily. This new one on Amazon that fits...

Not necessarily. This new one on Amazon that fits my D21 is 44.50, including shipping, and has good ratings. My local LKQ is quoting 41 bucks... but it cost three dollars to walk into the junkyard!...
Forum: Hardbody Forum (D21) 08-10-2017, 03:25 AM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
What did I do to my d21 today? I fucked up my MAF...

What did I do to my d21 today? I fucked up my MAF sensor, that's what I did. I'm still chasing down a fast idle condition and thought I'd clean the throttle body again and add some OxGard to the...
Forum: Hardbody Forum (D21) 08-07-2017, 04:52 PM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
Yep. We took the bed off my 92 to replace those...

Yep. We took the bed off my 92 to replace those hoses! But it also gave us time to patch some exhaust holes, ard on rust reformer and paint the whole undercarriage and spare tire.
Forum: General Discussion 08-07-2017, 04:49 PM
Replies: 72
Views: 5,360
Posted By Emendia
Forty bucks for a twenty years old used MAF?!...

Forty bucks for a twenty years old used MAF?! Highway robbery... literally!
Forum: General Discussion 08-07-2017, 04:45 PM
Replies: 72
Views: 5,360
Posted By Emendia
Holy shit, LKQ has an alters sign-up? I'm so on...

Holy shit, LKQ has an alters sign-up? I'm so on that! Thanks!
Forum: Exterior & Paint and Body 08-07-2017, 04:37 PM
Replies: 4
Views: 692
Posted By Emendia
Roll On Interlux Paint

I had been considering a rustoleum roll-on job on my old truck (I'm not looking to bring it up to show quality, just not looking like crap.). Much of the current talk about roll-on jobs has moved on...
Forum: Hardbody Forum (D21) 08-07-2017, 02:42 AM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
Tested the MAF sensor with a multimeter. Checked...

Tested the MAF sensor with a multimeter. Checked out OK... still chasing down a high idle condition.
Forum: Hardbody Forum (D21) 08-03-2017, 05:23 AM
Replies: 18,261
Views: 1,320,935
Posted By Emendia
Well, I'm fifty years old... so not quite diaper...

Well, I'm fifty years old... so not quite diaper age, but now AARP eligible. :facepalm:

As for today... sprayed starter fluid around searching for a vacuum leak. No dice. I don't think there is...
Showing results 1 to 25 of 53

 
Forum Jump

All times are GMT. The time now is 09:59 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.