Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 489
Search took 0.02 seconds.
Search: Posts Made By: Cusser
Forum: Early Frontier Forum (D22) 04-05-2020, 01:49 PM
Replies: 54
Views: 7,391
Posted By Cusser
Damn, you should. Actually, I've never...

Damn, you should.


Actually, I've never had any issues with O'Reilly before, and even the old Checker Auto receipts are in their system. But not this one (or its warranty replacement) for some...
Forum: Early Frontier Forum (D22) 04-04-2020, 11:39 PM
Replies: 54
Views: 7,391
Posted By Cusser
Took advantage of the Arizona virus slowdown and...

Took advantage of the Arizona virus slowdown and nice weather, swapped out the 4 shock absorbers on this (lifetime guaranteed). O'Reilly had ZERO record of the front shocks on their computers under...
Forum: General Discussion 04-01-2020, 06:40 PM
Replies: 79
Views: 1,003
Posted By Cusser
Mrs. Cusser and I in the mid-1980s. I actually...

Mrs. Cusser and I in the mid-1980s. I actually still have the bandannas.
https://i.imgur.com/34ePvdJ.jpg
Forum: General Discussion 03-31-2020, 01:33 PM
Replies: 79
Views: 1,003
Posted By Cusser
It's a 1988 Maytag A282 washing machine. ...

It's a 1988 Maytag A282 washing machine.




Too late, he drank it all; lots of bending down to do the floors !

And remember: we were all young once !!!
https://i.imgur.com/hxi7YSU.jpg
Forum: General Discussion 03-30-2020, 02:08 PM
Replies: 79
Views: 1,003
Posted By Cusser
Well, LHD D21 is tougher than I am. I bought a...

Well, LHD D21 is tougher than I am. I bought a place in cooler northern Arizona (near Prescott) in late 2004 just so I could have somewhere to escape the Phoenix heat which is pretty similar to...
Forum: General Discussion 03-29-2020, 02:23 PM
Replies: 79
Views: 1,003
Posted By Cusser
Try Phoenix AZ where we can have the summer LOW...

Try Phoenix AZ where we can have the summer LOW be 90 to 95F at like 5 am. I won't describe what 119F in the shade feels like in the sunshine.


There's no one outside except in their...
Forum: Engine and Drivetrain 03-28-2020, 01:15 PM
Replies: 30
Views: 341
Posted By Cusser
The CarQuest remanufactured starter in my '98...

The CarQuest remanufactured starter in my '98 Frontier has been fine since 2005.
Forum: General Discussion 03-28-2020, 01:13 PM
Replies: 79
Views: 1,003
Posted By Cusser
https://youtu.be/RdRNvSHjM3k

https://youtu.be/RdRNvSHjM3k
Forum: Hardbody Forum (D21) 03-27-2020, 01:18 PM
Replies: 37
Views: 574
Posted By Cusser
I installed an Autozone thermostat into my 2004...

I installed an Autozone thermostat into my 2004 Frontier last year when I did its leaky water pump. I had been getting a Check Engine Code on it, no longer. This was in a small town with only...
Forum: Hardbody Forum (D21) 03-27-2020, 01:13 PM
Replies: 36
Views: 4,220
Posted By Cusser
I have no idea if my '98 or 2004 Frontiers even...

I have no idea if my '98 or 2004 Frontiers even have a low fuel warning light, or if it even operates. I just use my fuel gauge.


Same for my 1988 Mazda truck, 1970 VW, 1971 VW.
Forum: Engine and Drivetrain 03-25-2020, 02:31 PM
Replies: 3
Views: 75
Posted By Cusser
Yes, arrow points in direction of the fuel flow.

Yes, arrow points in direction of the fuel flow.
Forum: Early Frontier Forum (D22) 03-24-2020, 01:50 PM
Replies: 54
Views: 7,391
Posted By Cusser
Nope. Rotors looked and felt good. That truck...

Nope. Rotors looked and felt good. That truck has the original drums as well, and has excellent braking.


I don't get rotors or drums turned unless there's a real need. The brake material is...
Forum: Engine and Drivetrain 03-21-2020, 01:22 PM
Replies: 18
Views: 176
Posted By Cusser
I've replaced the electrical part of the ignition...

I've replaced the electrical part of the ignition switch on my '98 Frontier. And on my 1988 Mazda truck. And on my 1970 VW. And on my 1971 VW.


What I'm saying is that this part gets a ton of...
Forum: Engine and Drivetrain 03-20-2020, 02:11 PM
Replies: 18
Views: 176
Posted By Cusser
This is a common issue with terminology meaning...

This is a common issue with terminology meaning different thins to different folks.






I'm going to take a guess that there's an issue with the contacts in the electrical part of the...
Forum: General Discussion 03-09-2020, 01:43 PM
Replies: 29
Views: 478
Posted By Cusser
On my '98, the cardboard was still OK after I...

On my '98, the cardboard was still OK after I pulled the drooping fabric off. I was hoping to take the cardboard out to recover, but was afraid the plastic in the rear of the cab would be too...
Forum: Wiring and Electrical 03-05-2020, 12:02 PM
Replies: 8
Views: 172
Posted By Cusser
Put DC voltmeter 0-20 volts across battery...

Put DC voltmeter 0-20 volts across battery terminals. Try to crank/start engine; while doing this record and post voltage about 3-4 seconds into trying. Should read over 9.6 volts !!!
Forum: Exterior & Paint and Body 03-01-2020, 03:37 PM
Replies: 40
Views: 18,483
Posted By Cusser
On my '88 Mazda truck, I can unbolt and tilt up...

On my '88 Mazda truck, I can unbolt and tilt up the truck bed for access to the fuel tank.



Some disconnect everything and pull the bed rearwards for access.
Forum: Engine and Drivetrain 03-01-2020, 03:35 PM
Replies: 9
Views: 178
Posted By Cusser
I would check the pump inlet and/or pump, do it...

I would check the pump inlet and/or pump, do it the original way.
Forum: Engine and Drivetrain 03-01-2020, 03:34 PM
Replies: 4
Views: 69
Posted By Cusser
Can you read/search all the letters and numbers...

Can you read/search all the letters and numbers on your old seal ?
Forum: Engine and Drivetrain 02-27-2020, 03:20 PM
Replies: 30
Views: 341
Posted By Cusser
Maybe a partially-broken plastic plug on the...

Maybe a partially-broken plastic plug on the clutch pedal, where it doesn't always make contact with the actuator on the safety switch???
Forum: Engine and Drivetrain 02-20-2020, 03:31 PM
Replies: 6
Views: 150
Posted By Cusser
Some times it's tough to get sufficient leverage...

Some times it's tough to get sufficient leverage while lying on one's back underneath !!!



And sometimes that correlates to auto mechanic stuff, not sex. With truck on a hoist, way easier to...
Forum: Engine and Drivetrain 02-10-2020, 02:50 PM
Replies: 28
Views: 443
Posted By Cusser
u-pick-it-arizona.com shows some Nissan trucks of...

u-pick-it-arizona.com shows some Nissan trucks of your year and within a few years. They have locations in Flagstaff and Prescott Valley.
Forum: Engine and Drivetrain 02-09-2020, 01:48 PM
Replies: 28
Views: 443
Posted By Cusser
About 30 years ago I removed the driveshaft on my...

About 30 years ago I removed the driveshaft on my 1979 Toyota truck, and took that to a machine shop and had new U-joints installed. Then re-installed the driveshaft.
Forum: General Discussion 02-03-2020, 03:03 PM
Replies: 29
Views: 478
Posted By Cusser
I have a '98 Frontier XE regular cab we bought...

I have a '98 Frontier XE regular cab we bought with 100K on it in 2004. By about 2012 or so, the fabric had come loose from the cardboard "ceiling" and was basically resting on driver's head and...
Forum: Early Frontier Forum (D22) 02-01-2020, 09:28 PM
Replies: 54
Views: 7,391
Posted By Cusser
Weather was 70F and sunny today, time to check...

Weather was 70F and sunny today, time to check the front brake pads on my 1998. One of the pads was getting narrow, so I picked up a set of warranty replacement Wagner MX333 and installed them. ...
Showing results 1 to 25 of 489

 
Forum Jump

All times are GMT. The time now is 06:23 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.