Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 119
Search took 0.01 seconds.
Search: Posts Made By: MidnightSun
Forum: Hardbody Forum (D21) 07-03-2022, 04:18 AM
Replies: 5
Views: 86
Posted By MidnightSun
I haven't had that problem, but have been having...

I haven't had that problem, but have been having a fair ammount of electrical things to work on lately, ha.

I took a look at the wiring diagram. It was tough to find, but located where the joint...
Forum: Project Build Log 05-23-2022, 11:25 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
No, the replacement ecu i got to see if it fixed...

No, the replacement ecu i got to see if it fixed the no start problem i had before, (Had also had intermittent ecu code pop up) is i believe from a 91 or there abouts out of a manual v6. Started...
Forum: Project Build Log 05-23-2022, 04:01 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
Yea, both tested within spec according to fsm. ...

Yea, both tested within spec according to fsm.

I know the wiring is kind of a mess in a couple areas. (The horn works intermittently as well) since i had gotten the vehicle there was a small...
Forum: Project Build Log 05-22-2022, 06:47 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
Went through the tps, wide open switch, closed...

Went through the tps, wide open switch, closed switch. I ended up not going through the ignition system again. I just went through that last month or so ago. A little lost and discouraged at this...
Forum: Project Build Log 05-22-2022, 05:17 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
Ugh, the problems cease to stop. :bang: After...

Ugh, the problems cease to stop. :bang:
After i got it running, i had it sitting idle as i set up the stereo. About 30 mins or so. Never showed signs of problems. This has been my first weekend off...
Forum: Project Build Log 05-07-2022, 11:22 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
After a few weekends off with never ending rain,...

After a few weekends off with never ending rain, i was finally able to put in the replacement ecu, and she fired right up. My afr gauge is showing lean, but it was starting to kind of level out to...
Forum: For Sale or Trade 05-07-2022, 11:15 PM
Replies: 14
Views: 727
Posted By MidnightSun
They are still available.

They are still available.
Forum: Im Looking For . . . 04-06-2022, 05:22 PM
Replies: 4
Views: 84
Posted By MidnightSun
When i had ordered my headers for the v6 it ended...

When i had ordered my headers for the v6 it ended up having a couple months lead time, another 2 weeks for the ceramic(?) coating. I may have ordered them from summit. Cant remember.
Forum: Project Build Log 04-01-2022, 02:43 AM
Replies: 81
Views: 8,209
Posted By MidnightSun
The only grounds i took off were the two on the...

The only grounds i took off were the two on the intake manifold. Eventually ill want to get a new ground from the battery, its wearing a bit but still giving good ground. Theres one flat ground that...
Forum: Project Build Log 03-31-2022, 10:34 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
After finding out I was doing the wrong test on...

After finding out I was doing the wrong test on the Power Transistor, resistance to measure continuity vs directional continuity, I tested again. I was getting a .5-.6 v reading on both old and...
Forum: Project Build Log 03-31-2022, 12:35 AM
Replies: 81
Views: 8,209
Posted By MidnightSun
Thanks. The real test will be how well it holds...

Thanks. The real test will be how well it holds up. It feels pretty solid. Was a fun project, my first time attempting one like that. Still in the plans is a center console, may try a vinyl wrap on...
Forum: Project Build Log 03-30-2022, 11:18 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
Heres that photo dump. ...

Heres that photo dump.
https://imgur.com/a/3ExpxlW
Forum: Project Build Log 03-30-2022, 09:52 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
I'll look at getting them on imgur, otherwise its...

I'll look at getting them on imgur, otherwise its just a matter of getting them on the computer.



That would be great. Ill get those things together and send it on over to you.
Forum: Project Build Log 03-30-2022, 06:19 PM
Replies: 81
Views: 8,209
Posted By MidnightSun
So a bit of an update. Pictures will have to come...

So a bit of an update. Pictures will have to come later. Found out that an update on the phone got rid of being able to resize the photos, so ill have to get them on the computer to resize.

First...
Forum: Engine and Drivetrain 03-12-2022, 09:00 PM
Replies: 1
Views: 50
Posted By MidnightSun
Tested the fuel pressure. Built up and slowly...

Tested the fuel pressure. Built up and slowly faded until it got down around 20psi and it stabalized. I had confirmed that none of the injectors leaked before putting everything together. Could it...
Forum: Engine and Drivetrain 03-12-2022, 08:50 PM
Replies: 1
Views: 50
Posted By MidnightSun
Sudden poor idle, bad vacuum

I just got done doing a fair bit of work to the truck. Have already done the vg33 swap. Was running the vg30 maf and injectors. Has been running good. My truck was down for awhile due to my transfer...
Forum: Hardbody Forum (D21) 01-22-2022, 02:14 AM
Replies: 25
Views: 1,322
Posted By MidnightSun
I dont think i have many pics other than the one...

I dont think i have many pics other than the one i snapped for the reply. All i did was take out all the lines, resevoir, ps pump(since its on its own belt), and swapped boxes. I cant recal spline...
Forum: Engine and Drivetrain 01-21-2022, 09:49 PM
Replies: 2
Views: 63
Posted By MidnightSun
Heres a picture. ...

Heres a picture.

http://www.infamousnissan.com/forum/picture.php?albumid=3186&pictureid=21058

I guess i should have done more searching, sounds like just any tcase from this gen will bolt up....
Forum: Hardbody Forum (D21) 01-21-2022, 08:55 PM
Replies: 25
Views: 1,322
Posted By MidnightSun
I did the change to manual steering. I ended up...

I did the change to manual steering. I ended up pretty much just making a new lower steering shaft. Got a splined coupler to a rod with splines on one end, cut to length, and a ujoint to the steering...
Forum: Engine and Drivetrain 01-21-2022, 07:47 PM
Replies: 2
Views: 63
Posted By MidnightSun
Unable to find transfer case rebuild

Hey guys. I had posted up awhile ago about a locked up rear end. Took the diff apart to find out it all looked good. Drained all the fluid from the drivetrain and discovered the transfer case had no...
Forum: Hardbody Forum (D21) 12-27-2021, 04:51 PM
Replies: 11
Views: 202
Posted By MidnightSun
Hopefully thats all it is. Soon ill beable to dig...

Hopefully thats all it is. Soon ill beable to dig into it. Finishing up working on an s10. PIA to work on, at least for the brake booster and 4wd vacuum.
Forum: Hardbody Forum (D21) 12-24-2021, 09:30 PM
Replies: 11
Views: 202
Posted By MidnightSun
Yea, that was my thoughts. No, i havent. That...

Yea, that was my thoughts. No, i havent. That will change soon enough though, ha. My plan is to start at the back and work my way forward.
Forum: Hardbody Forum (D21) 12-24-2021, 06:28 PM
Replies: 11
Views: 202
Posted By MidnightSun
I made it back up to MN without any problems....

I made it back up to MN without any problems. Took a one hr trip for some supplies and the rear end locked up on me. With both tansfer case and tranny in neutral i couldnt push it. Got a tow coming...
Forum: Engine and Drivetrain 12-21-2021, 07:26 PM
Replies: 14
Views: 256
Posted By MidnightSun
I have a set of headers up for sale. Could...

I have a set of headers up for sale. Could probably just not put the ypipe on, get it custom finished to the back?
Forum: Hardbody Forum (D21) 12-18-2021, 06:34 PM
Replies: 11
Views: 202
Posted By MidnightSun
@jp thats interesting. It would make sense of...

@jp thats interesting. It would make sense of the oil around the starter without a visible leak. I can see if i can get a view of the flywheel, see if theres oil up there. Also try to drain the oil...
Showing results 1 to 25 of 119

 
Forum Jump

All times are GMT. The time now is 04:04 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.