Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.17 seconds.
Search: Posts Made By: ahardb0dy
Forum: Im Looking For . . . Yesterday, 12:29 AM
Replies: 11
Views: 43
Posted By ahardb0dy
2 Different part numbers came up using the Vin...

2 Different part numbers came up using the Vin number but both were superseded by the 2 numbers I posted.
Forum: Im Looking For . . . Yesterday, 12:14 AM
Replies: 11
Views: 43
Posted By ahardb0dy
if you have a vin number I can double check the...

if you have a vin number I can double check the numbers
Forum: Introductions Yesterday, 12:07 AM
Replies: 4
Views: 38
Posted By ahardb0dy
No,you need to pull the distributor and the oil...

No,you need to pull the distributor and the oil pump to reset the oil pump/distributor shaft. Don't have to touch the timing chain. Would be a good time to replace the oil pump. The distributor will...
Forum: Im Looking For . . . Yesterday, 12:00 AM
Replies: 11
Views: 43
Posted By ahardb0dy
11232-01G10 comes up for the Z24 engine ...

11232-01G10 comes up for the Z24 engine
11233-01G00 so does this part number


I get part numbers:


11232-09G13 pass side (discontinued)
11233-09G13 Dr. side (discontinued)
Forum: Introductions 09-17-2018, 11:57 PM
Replies: 5
Views: 23
Posted By ahardb0dy
Welcome to Infamous

Welcome to Infamous
Forum: Introductions 09-17-2018, 11:57 PM
Replies: 4
Views: 38
Posted By ahardb0dy
Welcome to Infamous, The engine will run fine...

Welcome to Infamous, The engine will run fine even if the oil shaft is 180 degrees off, as long as the plug wires are moved to the matching locations on the cap.


My truck was like that for a...
Forum: Hardbody Forum (D21) 09-16-2018, 09:04 PM
Replies: 36
Views: 238
Posted By ahardb0dy
Trans fluid didn't seem like it was doing...

Trans fluid didn't seem like it was doing anything so I dumped it and filled the bottle with PB Blaster
Forum: Hardbody Forum (D21) 09-16-2018, 05:23 PM
Replies: 36
Views: 238
Posted By ahardb0dy
I removed the cable and am trying to get it to...

I removed the cable and am trying to get it to free up, saw this video on Youtube and am trying the guys technique, except I'm using transmission fluid:


https://youtu.be/8qcNwET6BX0


Also...
Forum: Wiring and Electrical 09-16-2018, 02:36 PM
Replies: 6
Views: 48
Posted By ahardb0dy
Headlight switch contacts may be dirty, you can...

Headlight switch contacts may be dirty, you can take the switch out and remove the white plastic cover to get to the copper fingers, hit the fingers and metal pads below the fingers with some fine...
Forum: Hardbody Forum (D21) 09-16-2018, 02:16 PM
Replies: 36
Views: 238
Posted By ahardb0dy
Today I'm going to remove the pass. side brake...

Today I'm going to remove the pass. side brake cable and see if I can free it up, if not I'll just leave it off until I can get another one.
Forum: Hardbody Forum (D21) 09-16-2018, 02:14 PM
Replies: 4
Views: 53
Posted By ahardb0dy
Fuel gauge issue

My fuel gauge always reads lower than the actual fuel level. When I fill the tank it never goes to the full mark.


I'm used to that and also used to the fact that when the gauge is on the "E"...
Forum: Wiring and Electrical 09-16-2018, 02:09 PM
Replies: 6
Views: 48
Posted By ahardb0dy
Does your truck have a trailer harness? If so I...

Does your truck have a trailer harness? If so I would check the connections to the OEM wires, trailer harnesses are the #1 problem for light related problems.


There is no relay for the...
Forum: Hardbody Forum (D21) 09-16-2018, 02:42 AM
Replies: 36
Views: 238
Posted By ahardb0dy
I sprayed some PB blaster into the sheath...

I sprayed some PB blaster into the sheath already, I pulled on the end as hard as I could and it didn't move at all. Maybe the lube will work in and it will free up.


I will say that once I...
Forum: Hardbody Forum (D21) 09-16-2018, 01:51 AM
Replies: 36
Views: 238
Posted By ahardb0dy
No kink, I don't think the cable was causing any...

No kink, I don't think the cable was causing any problems as it is frozen in the not engaged position
Forum: Hardbody Forum (D21) 09-16-2018, 12:25 AM
Replies: 36
Views: 238
Posted By ahardb0dy
Found out the pass, side E-brake cable is...

Found out the pass, side E-brake cable is separate from the other side. I took the front end of the cable off the other cable and unbolted the first mount, put a pry bar through the square part and...
Forum: Hardbody Forum (D21) 09-15-2018, 09:44 PM
Replies: 36
Views: 238
Posted By ahardb0dy
So I investigated the E-brake, this is what I...

So I investigated the E-brake, this is what I found.


The drivers side works properly but when you pull the E-brake the pass. side does not move at all.


I went under the truck where there is...
Forum: Hardbody Forum (D21) 09-15-2018, 08:14 PM
Replies: 36
Views: 238
Posted By ahardb0dy
OK, both sides back together, still have to bleed...

OK, both sides back together, still have to bleed the brakes but notice something isn't right with the E-brake,


If I pull the E-brake the drivers side rear tire will hold tight but the pass....
Forum: Hardbody Forum (D21) 09-15-2018, 05:12 PM
Replies: 36
Views: 238
Posted By ahardb0dy
OK, so today to make sure it was a brake problem...

OK, so today to make sure it was a brake problem and not something else, I took the drum off and was able to turn the axle freely, so that told me it was definitely a brake problem.


I than took...
Forum: Hardbody Forum (D21) 09-15-2018, 04:39 PM
Replies: 36
Views: 238
Posted By ahardb0dy
The way these were fitting you couldn’t get any...

The way these were fitting you couldn’t get any amount of spin on them
Forum: Hardbody Forum (D21) 09-15-2018, 04:38 PM
Replies: 36
Views: 238
Posted By ahardb0dy
I figured it out, details to come with pics !

I figured it out, details to come with pics !
Forum: Hardbody Forum (D21) 09-15-2018, 03:38 AM
Replies: 36
Views: 238
Posted By ahardb0dy
Checked the part number the shoes and drums are...

Checked the part number the shoes and drums are correct.


4x4 uses larger shoes and drums
Forum: Hardbody Forum (D21) 09-15-2018, 01:46 AM
Replies: 36
Views: 238
Posted By ahardb0dy
I shouldn't have too, with the star adjuster all...

I shouldn't have too, with the star adjuster all the way backed off, I should have to adjust the breaks after I put it back together to get some drag. I don't think there should be this much drag...
Forum: Hardbody Forum (D21) 09-15-2018, 01:45 AM
Replies: 36
Views: 238
Posted By ahardb0dy
Was thinking, tomorrow I'm going to try to spin...

Was thinking, tomorrow I'm going to try to spin the tire without the brake shoe and see what happens.


Since I have an open diff, and I already know the pass. side spins freely without the drum...
Forum: Hardbody Forum (D21) 09-14-2018, 10:54 PM
Replies: 36
Views: 238
Posted By ahardb0dy
No, but I know which old pad was where, you can...

No, but I know which old pad was where, you can see the mark where the emergency brake pin goes through the hole on the upper end of the shoe.


The brakes are pretty simple, I was going to take a...
Forum: Hardbody Forum (D21) 09-14-2018, 10:23 PM
Replies: 36
Views: 238
Posted By ahardb0dy
Found this online: "“Automotive brake...

Found this online:


"“Automotive brake shoes consist of a primary and secondary shoe. The primary brake shoe is the front shoe and normally has a slightly shorter lining than the...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 05:30 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.