Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.12 seconds.
Search: Posts Made By: cadillacdude1975
Forum: Hardbody Forum (D21) 03-24-2019, 07:16 AM
Replies: 19,239
Views: 1,413,380
Posted By cadillacdude1975
Yeah it was one of those moments where I sat...

Yeah it was one of those moments where I sat there shaking my head.
Forum: Introductions 03-24-2019, 02:52 AM
Replies: 9
Views: 75
Posted By cadillacdude1975
Double cab? Lucky. We never had that option here...

Double cab? Lucky. We never had that option here in the states.

Welcome to IN.
Forum: Hardbody Forum (D21) 03-24-2019, 02:50 AM
Replies: 19,239
Views: 1,413,380
Posted By cadillacdude1975
What did I do? I hit the damn thing today while...

What did I do? I hit the damn thing today while changing tractors around at the yard. When I pulled forward to unhook the tractor, I had a stupid moment. I knew my truck was there, and I pulled out...
Forum: Engine and Drivetrain 03-19-2019, 12:50 AM
Replies: 9
Views: 84
Posted By cadillacdude1975
The only way the cam could be installed wrong is...

The only way the cam could be installed wrong is not being timed correctly IE number one valves not closed when the piston is sitting on TDC.
Forum: Hardbody Forum (D21) 03-19-2019, 12:47 AM
Replies: 25
Views: 208
Posted By cadillacdude1975
Take a peek at www.car-part.com

Take a peek at www.car-part.com
Forum: Introductions 03-19-2019, 12:45 AM
Replies: 5
Views: 51
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: Hardbody Forum (D21) 03-19-2019, 12:43 AM
Replies: 18
Views: 177
Posted By cadillacdude1975
This exact bullshit problem is why I ripped every...

This exact bullshit problem is why I ripped every piece of pollution control and fuel injection off my truck and carbureted the damn thing.
Forum: Engine and Drivetrain 03-17-2019, 01:33 PM
Replies: 9
Views: 84
Posted By cadillacdude1975
With the engine at top dead center and both...

With the engine at top dead center and both valves closed, the rotor should point to be number one wire on the cap. Now if that happens to be close to the number one cylinder you are good. It sounds...
Forum: Engine and Drivetrain 03-17-2019, 01:28 PM
Replies: 7
Views: 70
Posted By cadillacdude1975
Yeah I see that now that I am awake lol Does...

Yeah I see that now that I am awake lol

Does the clutch fork have sufficient resistance if you try to push it by hand? The throwout bearing is only under load with the clutch pressed. Did you have...
Forum: Engine and Drivetrain 03-17-2019, 09:09 AM
Replies: 7
Views: 70
Posted By cadillacdude1975
What does it do when you start the engine? Does...

What does it do when you start the engine? Does it sit still with it in gear or does it move?
Forum: Engine and Drivetrain 03-17-2019, 09:05 AM
Replies: 13
Views: 1,018
Posted By cadillacdude1975
https://postimg.cc/30M0NN9q The kit is sold...

https://postimg.cc/30M0NN9q

The kit is sold on eBay. Search for the Nissan D21 Weber carburetor kit.
Forum: Introductions 03-17-2019, 09:02 AM
Replies: 4
Views: 66
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: Engine and Drivetrain 03-15-2019, 03:41 AM
Replies: 9
Views: 84
Posted By cadillacdude1975
Towards the actual plug hole or the number one...

Towards the actual plug hole or the number one post on the cap?
Forum: Introductions 03-15-2019, 03:36 AM
Replies: 8
Views: 146
Posted By cadillacdude1975
I use www.postimg.cc

I use www.postimg.cc
Forum: Hardbody Forum (D21) 03-14-2019, 08:44 PM
Replies: 19,239
Views: 1,413,380
Posted By cadillacdude1975
The old school trick is to do drums one side at a...

The old school trick is to do drums one side at a time. That way you always have a correctly assembled reference point. I have done drum brakes so many times in my 46 years, i could do them in my...
Forum: Engine and Drivetrain 03-14-2019, 08:42 PM
Replies: 9
Views: 75
Posted By cadillacdude1975
Probably a seal going bad. When the trans cools...

Probably a seal going bad. When the trans cools down, the seal shrinks. As the fluid warms up, it expands. It could also be sludge in the fluid causing a shift solenoid to stick.
Forum: Engine and Drivetrain 03-14-2019, 06:17 PM
Replies: 9
Views: 75
Posted By cadillacdude1975
When I serviced the Lexus, I used valvoline...

When I serviced the Lexus, I used valvoline maxlife atf.
Forum: Introductions 03-14-2019, 06:14 PM
Replies: 8
Views: 146
Posted By cadillacdude1975
Got a pic of that vent valve? I had to replace...

Got a pic of that vent valve? I had to replace the vent valve on my 91 Mercedes last summer. It was broken and directly venting fuel vapor under the car and it smelled like 20 gallons had been...
Forum: Engine and Drivetrain 03-14-2019, 06:11 PM
Replies: 5
Views: 64
Posted By cadillacdude1975
Another vote for the head gasket as...

Another vote for the head gasket as well......unless it has an awful amount of chain rattling at cold start.
Forum: Hardbody Forum (D21) 03-13-2019, 07:07 PM
Replies: 7
Views: 132
Posted By cadillacdude1975
The throwout bearing is only under load when the...

The throwout bearing is only under load when the clutch pedal is held to the floor. It could be the input shaft bearing raising hell. Has the trans been serviced recently? I know you said Lucas was...
Forum: Project Build Log 03-13-2019, 04:53 AM
Replies: 20
Views: 392
Posted By cadillacdude1975
There are two threads here that involve the VG33...

There are two threads here that involve the VG33 swap. One is by deerhurst and the other is jp2code.
Forum: Introductions 03-11-2019, 09:46 PM
Replies: 11
Views: 153
Posted By cadillacdude1975
Welcome to IN.

Welcome to IN.
Forum: General Discussion 03-11-2019, 05:19 PM
Replies: 1,045
Views: 67,575
Posted By cadillacdude1975
They make them with the replaceable sights. My...

They make them with the replaceable sights. My dumbass ordered the wrong one.
Forum: Introductions 03-11-2019, 03:23 PM
Replies: 5
Views: 68
Posted By cadillacdude1975
David is top notch. Best used parts guy there is,...

David is top notch. Best used parts guy there is, and many of us have bought stuff from him over and over with zero problems.

And welcome to IN.
Forum: Wiring and Electrical 03-11-2019, 03:19 PM
Replies: 2
Views: 32
Posted By cadillacdude1975
My pump was dead when I got my truck. New direct...

My pump was dead when I got my truck. New direct replacements are usually under 20 bucks. I got mine off ebay.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 11:43 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.