Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 315
Search took 0.01 seconds.
Search: Posts Made By: Scott Turchin
Forum: Suspension 04-23-2020, 12:41 AM
Replies: 9
Views: 172
Posted By Scott Turchin
It too is "new", 4 years old new...and I have a...

It too is "new", 4 years old new...and I have a steering stabilizer attached to it.
But I won't be going Mogue.



Left wheel primarily but some on the right.


Right side ball joints have...
Forum: Suspension 04-20-2020, 11:47 PM
Replies: 9
Views: 172
Posted By Scott Turchin
Yup, checked it about 5 times now. I had the...

Yup, checked it about 5 times now.
I had the hub off, new calipers etc - Wheels are torqued on.


Back in 1986 my Datsun B-210 had this issue, was the idler arm.


And ironically I can see it...
Forum: Suspension 04-20-2020, 01:58 PM
Replies: 9
Views: 172
Posted By Scott Turchin
So in researching it turns out Nissan went...

So in researching it turns out Nissan went through Altrom but the company that ma kes the really high end OEM stuff is Sansei-555


Problem is finding a retailer other than NAPA. The idler arm...
Forum: Suspension 04-20-2020, 12:38 AM
Replies: 8
Views: 180
Posted By Scott Turchin
I cringed. That video.....OUCH.

I cringed.


That video.....OUCH.
Forum: Suspension 04-20-2020, 12:32 AM
Replies: 9
Views: 172
Posted By Scott Turchin
38 MPH SHimmy

So this reminds me of my old Datsun B-210. Bear with me.


Axles are not the problem either.
4 years ago I rebuilt the suspension on my 4x4, ground up - every bushing, ball joint, steering arm,...
Forum: Suspension 03-26-2020, 01:58 AM
Replies: 0
Views: 60
Posted By Scott Turchin
Exclamation 4WD Tie Rods With Dampner

So I went to Rockauto and ordered the inner tie rods and outer tie rods.


The inners specifically state for vehicles WITH OEM Dampner, of which I added TO my truck during hte last suspension...
Forum: Engine and Drivetrain 03-08-2020, 04:36 AM
Replies: 4
Views: 133
Posted By Scott Turchin
I could but the Nissan Stanza seal is the correct...

I could but the Nissan Stanza seal is the correct one, ordered on RockAuto or ebay....:)
Forum: Engine and Drivetrain 02-29-2020, 11:07 PM
Replies: 4
Views: 133
Posted By Scott Turchin
Will do - and if anyone needs that black P/S pump...

Will do - and if anyone needs that black P/S pump on the left, I've changed all the seals out on it but it does not fit my 96.


Thanks for hte info, will call them Monday!
Forum: Engine and Drivetrain 02-29-2020, 07:37 PM
Replies: 4
Views: 133
Posted By Scott Turchin
P/S seal - wrong one?

Truck was mfg'd in 7/1996, I ordered a Power Steering pump seal kit for it but it comes with the smaller seal. I don't get it?
Every single picture for every option truck shows hte smaller seal, yet...
Forum: Engine and Drivetrain 02-12-2020, 04:09 AM
Replies: 1
Views: 183
Posted By Scott Turchin
Switch to 10w-30 and it will go away, for a...

Switch to 10w-30 and it will go away, for a little while...
I always thouight 5w-30 was a tad thin.


It sounds like the plastic guides, mine rattled for about a year before I changed it.
...
Forum: Engine and Drivetrain 02-10-2020, 08:05 PM
Replies: 5
Views: 205
Posted By Scott Turchin
Me too but this belt squeeking thing has been...

Me too but this belt squeeking thing has been going on a couple of years, replaced idler pulleys and belts, new alternator when it went bad a few years ago but in the end it's like sh ocks going bad,...
Forum: Engine and Drivetrain 02-10-2020, 02:31 AM
Replies: 5
Views: 205
Posted By Scott Turchin
Interesting day - took a trip out and met dvdswan...

Interesting day - took a trip out and met dvdswan - he had a spare pump and came home, pulled mine off and found that his pump uses 14mm bolts and did not quite line up with my bracket, and I left...
Forum: Engine and Drivetrain 02-02-2020, 09:03 PM
Replies: 5
Views: 205
Posted By Scott Turchin
Power steering pump?

I Just did a search and read a thread about squeeking belts.


Previously was alternator, but this time I only tightened up the P/S and fan belt and problem went away - but feels like a load on...
Forum: Engine and Drivetrain 01-17-2020, 05:03 AM
Replies: 4
Views: 139
Posted By Scott Turchin
I would be prone to think adjustor backwards-...

I would be prone to think adjustor backwards- please do send a pic!


The springs are super tight, new wheel cylinder, in fact I think I did the whole kit-n-kaboodle a couple years ago.


*and*...
Forum: Engine and Drivetrain 01-05-2020, 04:20 AM
Replies: 4
Views: 139
Posted By Scott Turchin
Rear brake hanging

a few years ago I put new pads on, new wheel cylinders, and turned hte drums. But, it seems about every 1-2 years the back right hangs up on me and I have to pound the drum off, unwind the auto...
Forum: Engine and Drivetrain 12-12-2019, 05:33 AM
Replies: 2
Views: 98
Posted By Scott Turchin
Best exhaust kit?

I want to replace my ENTIRE exhaust system, at one shot.


Prefer a kit, I want quality, not worried about cost.


Not sure if I want or need a header but tell me your experience!!
Forum: General Discussion 10-04-2019, 04:12 AM
Replies: 6
Views: 186
Posted By Scott Turchin
Sometimes the simplist answer is the best answer....

Sometimes the simplist answer is the best answer.


Ironically after working on my VW it just dawned on me to do that, and I had just bled the back brakes and ABS solenoid so I checked it and...
Forum: General Discussion 09-29-2019, 10:46 PM
Replies: 6
Views: 186
Posted By Scott Turchin
Thanks, that gets me where I was almost at :) ...

Thanks, that gets me where I was almost at :)


I Found the solenoid and now I know where the sensor is, maybe time to change u-joints anyway :D
Forum: General Discussion 09-29-2019, 09:50 PM
Replies: 6
Views: 186
Posted By Scott Turchin
ABS and BRAKE lights on...

1996 4x4


I was expecting to find wheel sensors, rockauto.com shows them for my truck but there are no wires running back to the rear.


So how does the ABS know when the wheels are locked...
Forum: General Discussion 08-26-2019, 02:17 PM
Replies: 99
Views: 12,889
Posted By Scott Turchin
Interesting story - just sp ent $299 ($60 core)...

Interesting story - just sp ent $299 ($60 core) at Rock Auto.

NAPA quoted me $600 for the same parts.
Les Schwab used some sub-standard part 2 YEARS ago and I've had to replace 1 caliper and...
Forum: Exterior & Paint and Body 07-25-2019, 05:23 AM
Replies: 40
Views: 18,856
Posted By Scott Turchin
Bumping this thread up, I need to get this done...

Bumping this thread up, I need to get this done this weekend and lifting with a very large engine hoist looks to be my answer.


I just want tp replace the paint between bed/cab because it's at...
Forum: Exterior & Paint and Body 07-20-2019, 02:43 PM
Replies: 11
Views: 618
Posted By Scott Turchin
Man for $400 you guys should jump on this, it was...

Man for $400 you guys should jump on this, it was $708 after tax.
Forum: Exterior & Paint and Body 07-13-2019, 07:45 PM
Replies: 11
Views: 618
Posted By Scott Turchin
LineX complete

And WOW.


Unfortunately where I had slightly filled a ding, the LineX has lifted so back to the shop for them to fix it. Not a huge deal.
THe two dents in the right wheel bump really show but I...
Forum: Exterior & Paint and Body 07-05-2019, 07:13 PM
Replies: 6
Views: 349
Posted By Scott Turchin
Is it safe to just LineX over top of them then?

Is it safe to just LineX over top of them then?
Forum: Exterior & Paint and Body 07-05-2019, 05:00 PM
Replies: 6
Views: 349
Posted By Scott Turchin
They are just screws, thatís the question I was...

They are just screws, thatís the question I was looking for. I used my impact hammer to get four of them off, know where I can get a couple of these in a hurry?
Showing results 1 to 25 of 315

 
Forum Jump

All times are GMT. The time now is 05:13 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.