Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 78
Search took 0.02 seconds.
Search: Posts Made By: HighGear
Forum: Engine and Drivetrain 04-02-2015, 10:39 PM
Replies: 11
Views: 5,194
Posted By HighGear
I'm running 2" adapted to 3x18 thrush cherry bomb...

I'm running 2" adapted to 3x18 thrush cherry bomb with a 45 degree turn down. No cat. Pops and crackles like mad. At idle it sounds mean, I get asked up the engine upgrades constantly (none) pulling...
Forum: The Other Forum 04-02-2015, 08:40 PM
Replies: 6
Views: 1,818
Posted By HighGear
Well, weather is getting warmer. After sitting...

Well, weather is getting warmer. After sitting all winter in sub zero temps, the Suzuki fired up 3rd kick. Took a victory lap around the block. Now I just need motivation to work on the Kawi.

I...
Forum: Wiring and Electrical 04-02-2015, 04:37 AM
Replies: 11
Views: 1,283
Posted By HighGear
Just a tip, for ends and pieces, connectors and...

Just a tip, for ends and pieces, connectors and such try your local car audio store. They usually have the big ass hydraulic crimping tool to but them on as well.
Forum: Wiring and Electrical 03-30-2015, 01:30 PM
Replies: 12
Views: 1,405
Posted By HighGear
Didn't notice that. Thanks. I'll check there next...

Didn't notice that. Thanks. I'll check there next weekend.
Forum: Wiring and Electrical 03-30-2015, 11:32 AM
Replies: 12
Views: 1,405
Posted By HighGear
Yeah I checked the plug. Pink/blue pin is dead....

Yeah I checked the plug. Pink/blue pin is dead. So my issue is between the switch and the plug. Wired the tails to a toggle for now.
Forum: Wiring and Electrical 03-29-2015, 04:41 PM
Replies: 12
Views: 1,405
Posted By HighGear
Well still no juice to the back. All I can figure...

Well still no juice to the back. All I can figure is pinched wire between switch and socket
Forum: Wiring and Electrical 03-29-2015, 03:52 AM
Replies: 12
Views: 1,405
Posted By HighGear
New switch stalk installed. I now have a left...

New switch stalk installed. I now have a left turn signal.. Still no taillights or right signal. Going to test pins and sockets all again....
Forum: General Discussion 03-27-2015, 03:12 AM
Replies: 6
Views: 861
Posted By HighGear
Yes sir, nationwide there going under. Sad sad...

Yes sir, nationwide there going under. Sad sad days. I didn't visit the local store much, but when I did, it was for something only they carried that I needed pronto.
Forum: Wiring and Electrical 03-26-2015, 11:12 PM
Replies: 12
Views: 1,405
Posted By HighGear
After researching around, think I'm going to...

After researching around, think I'm going to replace the switch stalk.

I tested every wire at the plug next to the spare tire and didn't find a hot with headlights on. That's why I ran a jumper...
Forum: Wiring and Electrical 03-24-2015, 01:06 PM
Replies: 12
Views: 1,405
Posted By HighGear
There was a trailer harness, it was half ripped...

There was a trailer harness, it was half ripped off. I removed that when I matched everything. Everything up front works as it should. On the dash, left turn flashes normal, right hyper flashes.
Forum: Wiring and Electrical 03-24-2015, 12:03 PM
Replies: 12
Views: 1,405
Posted By HighGear
wiring mystery

So, when I bought my truck only the brake light, right turn signal and reverse lights worked. The harness was spliced to hell and back. I ran an alligator clip jumper off the dome light to the tail...
Forum: Engine and Drivetrain 03-19-2015, 04:28 AM
Replies: 8
Views: 1,127
Posted By HighGear
My bet is a crank or rod bearing. Had it happen...

My bet is a crank or rod bearing. Had it happen on a few motors now I've learned to despise that out of the blue grinding.
Forum: 4x4 and Offroading 02-17-2015, 04:11 PM
Replies: 14
Views: 2,734
Posted By HighGear
From my understanding, 4lo works by using a...

From my understanding, 4lo works by using a higher numerical gear ratio. Lowering speed and effectivelyincreasing torque to the wheels. Maybe hublocks, half-shafts, front gears, or the gears in the...
Forum: Engine and Drivetrain 02-09-2015, 07:26 PM
Replies: 9
Views: 1,825
Posted By HighGear
Definitely. I try not to whoop on her too much,...

Definitely. I try not to whoop on her too much, but I've made a bad habit of 5,000 rpm shifts when merging onto the highway.
Forum: Engine and Drivetrain 02-07-2015, 01:06 AM
Replies: 9
Views: 1,825
Posted By HighGear
I guess I should clarify, I'm not advocating for...

I guess I should clarify, I'm not advocating for everyone to go and cut theirs. I'm just saying after I removed mine, I had no noticeable effect.
Forum: Engine and Drivetrain 02-07-2015, 01:03 AM
Replies: 9
Views: 1,825
Posted By HighGear
Yeah I'm aware of the purpose of an O2. That's...

Yeah I'm aware of the purpose of an O2. That's kind of my point, I'd expect some sort of deficiency but it seems to not notice. It's not like I just run to the store, were talkin a 3+/- hour...
Forum: Engine and Drivetrain 02-06-2015, 05:29 PM
Replies: 9
Views: 1,825
Posted By HighGear
02 sensor Delete

So last month I was in a pinch for money, since my exhaust was junk anyways I cut the cat and scrapped it. The 02 was corroded into the pipe pretty bad so I just snipped the wires. Surprisingly it...
Forum: Exterior & Paint and Body 02-06-2015, 04:56 PM
Replies: 3
Views: 1,233
Posted By HighGear
Depending on the level of pitting, a good high...

Depending on the level of pitting, a good high build primer, maybe a skim coat of filler. Anyways good luck. Take pictures, I'm sure a lot of users would like to see some backyard rust repair.
Forum: Exterior & Paint and Body 02-04-2015, 01:44 PM
Replies: 3
Views: 1,233
Posted By HighGear
You're going to want to remove the paint from the...

You're going to want to remove the paint from the area. without knowing what tools you have, I'll assume you at least have a drill. Use a wire brush attachment and remove the rust. If it's just light...
Forum: Wheels and Tires 01-30-2015, 12:58 PM
Replies: 12
Views: 1,995
Posted By HighGear
I got my steel from Summit Racing, couldn't be...

I got my steel from Summit Racing, couldn't be happier. Cost like $250, free shipping. They got tons of styles in the under $400 market. Easier to get the offset/backspace , width you want for...
Forum: The Other Forum 01-28-2015, 11:44 AM
Replies: 6
Views: 1,818
Posted By HighGear
Oh yeah. I love the dual sports, I don't do much...

Oh yeah. I love the dual sports, I don't do much for real "off road" but the stability on gravel is amazing. Not to mention Michigan rough ass pavement. That old Suzuki will get up and go too. Top...
Forum: The Other Forum 01-27-2015, 04:11 PM
Replies: 6
Views: 1,818
Posted By HighGear
The Kawasaki... Well that one had some rust...

The Kawasaki... Well that one had some rust issues. As of now it's tore down.

http://i46.photobucket.com/albums/f129/HighGear5/IMAG0538_zps9eb1bfe3.jpg...
Forum: The Other Forum 01-27-2015, 04:02 PM
Replies: 6
Views: 1,818
Posted By HighGear
My Bikes

Figured I'd show case another money pit hobby I've tinkered with.

http://i46.photobucket.com/albums/f129/HighGear5/1078563_153512984842584_1905543888_o_zpsc18f4c0d.jpg...
Forum: Suspension 01-04-2015, 06:32 PM
Replies: 7
Views: 1,012
Posted By HighGear
Interesting turn of events, I jacked the truck up...

Interesting turn of events, I jacked the truck up to cut the cat off, need money, and now it's sitting normal with no blocks. The anchor arm is clearly broken, weird huh?
Forum: Suspension 12-27-2014, 04:28 PM
Replies: 7
Views: 1,012
Posted By HighGear
Ok a chunk of 2x4 got me about 1/8 inch of...

Ok a chunk of 2x4 got me about 1/8 inch of clearance, wedged it between the LCA and the frame. Heard it cracking when I let the Jack down. It's just pine so I don't really trust it.
Showing results 1 to 25 of 78

 
Forum Jump

All times are GMT. The time now is 06:44 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.