Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.10 seconds.
Search: Posts Made By: SBJ
Forum: Hardbody Forum (D21) Today, 02:55 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
A second person is handy for getting it lined up...

A second person is handy for getting it lined up on reinstall. Also leave it in gear so that if the splines on the input shaft don't 100% line up with the ones on the clutch you can rotate the...
Forum: Hardbody Forum (D21) Today, 02:33 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
I went out in the woods a couple times this past...

I went out in the woods a couple times this past fall. Recently I picked up one of those propane tank trees and a folding camp kitchen. That should make a nice addition to the 6' folding table I...
Forum: Hardbody Forum (D21) Today, 02:23 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
It's not a bad job at all. You really don't need...

It's not a bad job at all. You really don't need a jack, just bench press it out of the way and let the back of it rest on the crossmember. That'll give you plenty of room to get to everything.
Forum: Hardbody Forum (D21) 01-16-2019, 08:49 PM
Replies: 15
Views: 132
Posted By SBJ
Same, it's been almost 8 years since I deleted my...

Same, it's been almost 8 years since I deleted my account. Don't miss it. An RC one of these would be way cool. I remember when I was a kid I got a cheapo dodge viper RC car for christmas one...
Forum: Exterior & Paint and Body 01-16-2019, 06:05 AM
Replies: 7
Views: 108
Posted By SBJ
My bad. I read it as filter earlier.

My bad. I read it as filter earlier.
Forum: Hardbody Forum (D21) 01-16-2019, 05:43 AM
Replies: 10
Views: 144
Posted By SBJ
Same here. I have a 1999 camry myself and denso...

Same here. I have a 1999 camry myself and denso is all I use for sensors and electronics. I usually run NGK plugs in everything unless it's considerably more expensive. I'm going on a bit of a...
Forum: Hardbody Forum (D21) 01-16-2019, 02:51 AM
Replies: 10
Views: 144
Posted By SBJ
Denso wires are a good alternative. They are...

Denso wires are a good alternative. They are also made in Japan and are the OEM for Toyota and Honda and probably some others too. I looked at the NGKs but ended up going with the denso set because...
Forum: Hardbody Forum (D21) 01-15-2019, 09:18 PM
Replies: 3
Views: 38
Posted By SBJ
Ring gear bolts in the HF35 are 17mm, not sure...

Ring gear bolts in the HF35 are 17mm, not sure about the others. They may or may not be left-hand thread, no idea.
Forum: 4x4 and Offroading 01-14-2019, 10:10 PM
Replies: 18
Views: 197
Posted By SBJ
Gotcha. I grew up next door in the land of...

Gotcha. I grew up next door in the land of entrapment. I've been to Flagstaff a few times and it's pretty similar.
Forum: 4x4 and Offroading 01-14-2019, 08:41 PM
Replies: 18
Views: 197
Posted By SBJ
Glad you had fun. I gotta ask, where was this? ...

Glad you had fun. I gotta ask, where was this? The landscape looks a lot like where I grew up.
Forum: Hardbody Forum (D21) 01-14-2019, 01:41 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
I have gone to the car wash exactly once since...

I have gone to the car wash exactly once since moving down here. It was because a few days prior I had taken my car out in the woods to look for places to camp and in the process got it completely...
Forum: Hardbody Forum (D21) 01-13-2019, 08:59 PM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
But it does take more energy to heat it from -40F...

But it does take more energy to heat it from -40F to operating temp than from 30-40F to operating temp (what a lot of us in mild climates would consider to be cold). Full disclosure: I didn't do...
Forum: Hardbody Forum (D21) 01-13-2019, 03:29 AM
Replies: 58
Views: 738
Posted By SBJ
I gotta go buy some more popcorn...

I gotta go buy some more popcorn...
Forum: Exterior & Paint and Body 01-13-2019, 12:42 AM
Replies: 7
Views: 108
Posted By SBJ
Perhaps under the cab on the inside of the frame...

Perhaps under the cab on the inside of the frame rail, although that will likely require cutting and re-flaring the fuel line to make it work. A lot of trucks have it mounted there from the factory...
Forum: For Sale or Trade 01-12-2019, 09:01 PM
Replies: 6
Views: 77
Posted By SBJ
Seconding PaineTrain, it's a 95. The 10th digit...

Seconding PaineTrain, it's a 95. The 10th digit of the VIN on the door jamb sticker is an S, which denotes that it's a 95 model (T would be 1996).
Forum: Hardbody Forum (D21) 01-12-2019, 01:35 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
Mine spins tires on snow, ice and gravel. That's...

Mine spins tires on snow, ice and gravel. That's it.
Forum: General Discussion 01-11-2019, 06:19 PM
Replies: 1
Views: 69
Posted By SBJ
The floor's the limit. If it won't start you...

The floor's the limit. If it won't start you have a lot more bargaining power. First, are you sure it's the fuel pump and not something else like the relay or the immobilizer (Ford PATS system cuts...
Forum: Hardbody Forum (D21) 01-11-2019, 04:14 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
And pump out that 20 year old brake fluid before...

And pump out that 20 year old brake fluid before you start to drive it regularly.
Forum: Hardbody Forum (D21) 01-10-2019, 04:20 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
Emissions suck. I am thankful that I do not live...

Emissions suck. I am thankful that I do not live in CA or a metropolitan area that requires them. It would be kind of hard to pass the sniffer test without a functioning catalytic converter.
...
Forum: Hardbody Forum (D21) 01-10-2019, 03:08 AM
Replies: 18,823
Views: 1,369,946
Posted By SBJ
The feedback carburetors of the world would like...

The feedback carburetors of the world would like to have a word with you...

I say that in jest, of course. I know nothing about the emissions requirements in Australia and I'm assuming yours are...
Forum: Hardbody Forum (D21) 01-08-2019, 08:16 PM
Replies: 8
Views: 171
Posted By SBJ
The classic dex cool rust souffle.

The classic dex cool rust souffle.
Forum: Hardbody Forum (D21) 01-08-2019, 04:57 AM
Replies: 10
Views: 171
Posted By SBJ
Shit I'm lost now. I know I replaced mine with...

Shit I'm lost now. I know I replaced mine with regular old 194 bulbs re-using the existing housing and without any modification of the bulbs themselves. It's been so long since I've had the cluster...
Forum: Hardbody Forum (D21) 01-08-2019, 02:42 AM
Replies: 12
Views: 227
Posted By SBJ
Funny thing is I probably have at least $15 worth...

Funny thing is I probably have at least $15 worth of half-empty tubes of RTV lying around lol.
Forum: Hardbody Forum (D21) 01-08-2019, 02:36 AM
Replies: 10
Views: 171
Posted By SBJ
They are a pain if it's the first time they've...

They are a pain if it's the first time they've ever been changed. IIRC they are soldered on the bottom of the little holder thingy and I used a pocket screwdriver to break the solder. Then I just...
Forum: Hardbody Forum (D21) 01-07-2019, 05:54 AM
Replies: 12
Views: 227
Posted By SBJ
Oh man. Getting all fancy on us.

Oh man. Getting all fancy on us.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 08:55 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.