Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 75
Search took 0.01 seconds.
Search: Posts Made By: CharlaineC
Forum: Hardbody Forum (D21) 05-18-2020, 09:57 PM
Replies: 21,681
Views: 1,575,337
Posted By CharlaineC
Replaced airfilter oil breather assembly as well...

Replaced airfilter oil breather assembly as well as windshild washer pump. both under for under $3.bucks 11111111111111
Forum: For Sale or Trade 05-17-2020, 10:25 PM
Replies: 9
Views: 506
Posted By CharlaineC
a set of dark gray would be great as for the...

a set of dark gray would be great as for the latch the old owner of my truck had brought me a set of brand new ones.



do you have the locks for the two compartments under the jump seats? Also...
Forum: For Sale or Trade 05-16-2020, 08:42 PM
Replies: 9
Views: 506
Posted By CharlaineC
interested in the gray door handle set if you can...

interested in the gray door handle set if you can wait till the first
Forum: Engine and Drivetrain 05-16-2020, 08:41 PM
Replies: 8
Views: 98
Posted By CharlaineC
I have an brand new one i'm not using the the...

I have an brand new one i'm not using the the 2wd 4cyl engine
Forum: Hardbody Forum (D21) 05-08-2020, 10:27 PM
Replies: 33
Views: 798
Posted By CharlaineC
Newest additions to my girl New door...

Newest additions to my girl


New door speakers

Cb antenna mounted and wire installed.

New t-handle and locking bars installed in cap.

Installed new rear side window latches and gromits
Forum: Wiring and Electrical 05-08-2020, 10:10 PM
Replies: 15
Views: 254
Posted By CharlaineC
Following ahardb0dy...

Following ahardb0dy (http://www.infamousnissan.com/forum/member.php?u=8587)'s Advive I picked up the Wilson gumdrop. Mounted the antenna sadly its a little off center but not too bad. Was able to run...
Forum: For Sale or Trade 05-08-2020, 05:31 AM
Replies: 32
Sticky: Free stuffs!!!
Views: 5,105
Posted By CharlaineC
interested in the jack what year is steering...

interested in the jack
what year is steering from?
Forum: General Discussion 05-07-2020, 05:51 AM
Replies: 143
Views: 2,329
Posted By CharlaineC
Finally installed my CB antenna and CB just need...

Finally installed my CB antenna and CB just need to wire it up. Replaced the t-handle and hardware for the cap and new set of belts. As well as replaced the rear windo latches. As well as installed...
Forum: General Discussion 05-06-2020, 05:00 AM
Replies: 136
Views: 8,919
Posted By CharlaineC
Scored a good 1968-1975 Ford/chevy bottle jack...

Scored a good 1968-1975 Ford/chevy bottle jack for my truck as well as a complete t-handle and locking bar assembly with keys.
Forum: Introductions 05-06-2020, 04:58 AM
Replies: 6
Views: 83
Posted By CharlaineC
Welcome from the Spokane/Cheney area

Welcome from the Spokane/Cheney area
Forum: Wiring and Electrical 05-06-2020, 04:58 AM
Replies: 8
Views: 115
Posted By CharlaineC
sorry for the delay in response I've been dealing...

sorry for the delay in response I've been dealing with a family emergancy the last 2.5 weeks. so was on rearly.

I like the duel door speakers they fit perfectly. And honestly they work well with...
Forum: Wiring and Electrical 04-30-2020, 07:29 PM
Replies: 8
Views: 115
Posted By CharlaineC
rear speaker recamendations

Okay I'm at a loss. Can some please help me find a set of speakers that will fit in the old rear housing with little to no drilling. I bought a full set of duel's front and rear but the rears are way...
Forum: Engine and Drivetrain 04-03-2020, 10:02 AM
Replies: 3
Views: 72
Posted By CharlaineC
Airfilter question

Ok this might sound dumb I went to change out the old air filter for a clean one and found the stp filter that was for the truck didn't sit properly in the housing. It wasn't tall enough to seal. Is...
Forum: Hardbody Forum (D21) 03-29-2020, 06:51 PM
Replies: 10
Views: 3,021
Posted By CharlaineC
Is this only for 4x4?

Is this only for 4x4?
Forum: Hardbody Forum (D21) 03-24-2020, 12:43 AM
Replies: 36
Views: 1,006
Posted By CharlaineC
check this place out for replacement floor pans ...

check this place out for replacement floor pans
I used my truck to look it up but they should have yours as well

https://www.carid.com/universal-floor-pans/?vehicle=5889
Forum: Introductions 03-18-2020, 11:21 AM
Replies: 7
Views: 149
Posted By CharlaineC
What is it you need done exactly I'm in the...

What is it you need done exactly I'm in the Spokane area but have done many drillouts and thread cuts. Maybe I'm suddenly blonde but your post left me scratching me head
Forum: Exterior & Paint and Body 03-13-2020, 02:25 AM
Replies: 11
Views: 541
Posted By CharlaineC
I love mine only issue i have is that when it...

I love mine only issue i have is that when it gets windy the truck get squirrelly with side winds. I need pistons and the lock bars for mine
Forum: Im Looking For . . . 03-12-2020, 09:42 AM
Replies: 2
Views: 106
Posted By CharlaineC
Window latch d21

I'm looking for the driver-side latch for the window behind the jump seat. if anyone has an extra et me know and what youd like for it. just found out my window is held closed with bailing wire
Forum: Hardbody Forum (D21) 03-12-2020, 09:35 AM
Replies: 33
Views: 798
Posted By CharlaineC
No I didn't take the leather ones from the 97...

No I didn't take the leather ones from the 97 pathfinder as they were in bad shape and I didn't want to mess with the electric aspects of installing them. Though I did think about it lol
Forum: Hardbody Forum (D21) 03-11-2020, 04:17 AM
Replies: 33
Views: 798
Posted By CharlaineC
Installed two new seats in my girl. nice to not...

Installed two new seats in my girl. nice to not have the back of driver seat held uo by trash can lol
Forum: Hardbody Forum (D21) 03-11-2020, 04:15 AM
Replies: 21,681
Views: 1,575,337
Posted By CharlaineC
went to the junk today to score a few little...

went to the junk today to score a few little parts as i was low on funds.found two nice seats. pulled them to have them held for me. Find $50 bill wedged under the track.now have 2 newer seats and...
Forum: Wiring and Electrical 02-15-2020, 08:21 AM
Replies: 15
Views: 254
Posted By CharlaineC
i'm running the cobra 29lx so shes a big one. i'm...

i'm running the cobra 29lx so shes a big one. i'm thinking of running her on the hump next to the shift at an angle. if i cant fit it under the radio
Forum: Wiring and Electrical 02-13-2020, 05:20 AM
Replies: 15
Views: 254
Posted By CharlaineC
My next question is best place to mount her I was...

My next question is best place to mount her I was thinking under the radio and cubby

in front of the shift
Forum: Wiring and Electrical 02-10-2020, 07:18 PM
Replies: 15
Views: 254
Posted By CharlaineC
I guessi'll have to look into mounting on the...

I guessi'll have to look into mounting on the roof then. I'm running a 5' firestik. I was just looking at a ball mount that allows for attachment any angle so I might go with that.
Forum: Wiring and Electrical 02-07-2020, 05:00 PM
Replies: 15
Views: 254
Posted By CharlaineC
thanls i'll look into that

thanls i'll look into that
Showing results 1 to 25 of 75

 
Forum Jump

All times are GMT. The time now is 07:23 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.