Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums
Reload this Page Search Results
Mark Forums Read
IN Store Register FAQ Members List Calendar Search Today's Posts

Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.06 seconds. Search: Posts Made By: Deerhurst
Forum: Interior & Audio/Video Yesterday, 10:25 PM
Replies: 5
Views: 37
Posted By Deerhurst
I ended up epoxying the pin on the cable. It...

I ended up epoxying the pin on the cable. It wears inside as it goes and no longer holds the cable end.
Forum: Engine and Drivetrain Yesterday, 01:07 PM
Replies: 15
Views: 132
Posted By Deerhurst
Thatll do it! Also, NGK is...

Thatll do it!





Also, NGK is recommended for all things spark related in these trucks. Most of us only run NGK plugs and wires.
Forum: Interior & Audio/Video Yesterday, 01:04 AM
Replies: 5
Views: 37
Posted By Deerhurst
If it's related to the thingy in the back your...

If it's related to the thingy in the back your needle is probably just fine. The plastic thing is probably slipping on the speedo cable it clips onto. There is a sticky in the D21 section about this.
Forum: Engine and Drivetrain 04-12-2021, 10:38 PM
Replies: 9
Views: 56
Posted By Deerhurst
I'd just get one that is the same diameter and...

I'd just get one that is the same diameter and either use a sleeve type clamp or have it welded. The cat will be the expensive part. It's only a few minutes to do the weld.



I'm with you...
Forum: Engine and Drivetrain 04-12-2021, 07:54 PM
Replies: 9
Views: 56
Posted By Deerhurst
You may have trouble online finding people to...

You may have trouble online finding people to help with a cat delete on a road vehicle because even if your state, like mine, does not do emissions testing in your area a cat is still a federally...
Forum: Engine and Drivetrain 04-10-2021, 05:00 PM
Replies: 18
Views: 405
Posted By Deerhurst
My Audi don't really care. It's got torque in...

My Audi don't really care. It's got torque in spades down low. Same with most diesels I've driven. They don't really care about a little compressor with 750+ ftlbs.
Forum: Engine and Drivetrain 04-10-2021, 12:17 AM
Replies: 18
Views: 405
Posted By Deerhurst
My sentra was that way. Turn off the AC for...

My sentra was that way. Turn off the AC for instant powerful passing turtles!
Forum: Hardbody Forum (D21) 04-09-2021, 01:11 AM
Replies: 5
Views: 67
Posted By Deerhurst
Pic no worky.

Pic no worky.
Forum: Wiring and Electrical 04-08-2021, 11:53 PM
Replies: 13
Views: 114
Posted By Deerhurst
Thanks for the update! We like when stuff is...

Thanks for the update! We like when stuff is fixed!
Forum: Hardbody Forum (D21) 04-08-2021, 07:51 PM
Replies: 12
Views: 174
Posted By Deerhurst
KA24. What mode is your ECM in when...

KA24.



What mode is your ECM in when it gives you a green light?



Do you have a copy of the FSM?
Forum: Wiring and Electrical 04-08-2021, 04:53 PM
Replies: 9
Views: 3,054
Posted By Deerhurst
The check connector is present back to 86.5 but...

The check connector is present back to 86.5 but non functional on 86.5 due to ECM limitations. It's missing the trigger pin.
Forum: Hardbody Forum (D21) 04-08-2021, 01:14 AM
Replies: 22,887
Views: 1,672,273
Posted By Deerhurst
Yours?

Yours?
Forum: General Discussion 04-08-2021, 01:13 AM
Replies: 19
Views: 197
Posted By Deerhurst
Ordered a Fenix UC35. It's a little fatter than...

Ordered a Fenix UC35. It's a little fatter than I'd like but 1000lms and rechargable with brightness modes down to 1lm which is nice for inside electrical cabinets and mahines so I don't blind myself...
Forum: Hardbody Forum (D21) 04-07-2021, 11:30 PM
Replies: 18
Views: 150
Posted By Deerhurst
Is your ECM a later one with multiple modes or...

Is your ECM a later one with multiple modes or just with a switch like the early ones?
Forum: Hardbody Forum (D21) 04-07-2021, 10:43 PM
Replies: 22,887
Views: 1,672,273
Posted By Deerhurst
Yikes and what a tiny piston!

Yikes and what a tiny piston!
Forum: Engine and Drivetrain 04-07-2021, 10:42 PM
Replies: 15
Views: 132
Posted By Deerhurst
I'm not sure if it is smart enough to figure out...

I'm not sure if it is smart enough to figure out what is outside range like a new vehicle. My car will say "implausible signal" but I think the D21 can only tell if it there or not. Might be worth...
Forum: Hardbody Forum (D21) 04-07-2021, 08:07 PM
Replies: 18
Views: 150
Posted By Deerhurst
I was thinking temp sender. I'm curious for an...

I was thinking temp sender. I'm curious for an update from the OP.
Forum: Engine and Drivetrain 04-07-2021, 08:06 PM
Replies: 15
Views: 132
Posted By Deerhurst
I don't think the speed sensor would do that but...

I don't think the speed sensor would do that but it's possible.



As it was fine when cold but barfed when hot I'd look into the temp sender. It's in the front of the driver's side head. You'll...
Forum: General Discussion 04-07-2021, 08:02 PM
Replies: 19
Views: 197
Posted By Deerhurst
I have an oooolllllddddd G2 Nitrolon from when...

I have an oooolllllddddd G2 Nitrolon from when surefire was a brand new company selling lights at smaller gun shows. Paid $20 for it! It's an awesome light! I have the original rechargeable kit,...
Forum: General Discussion 04-07-2021, 08:00 PM
Replies: 19
Views: 197
Posted By Deerhurst
I had an old Protac so it was closer to 90lms....

I had an old Protac so it was closer to 90lms. That second link looks good! Little too big for my EDC.



Hard to find a slim light with good lumens.



I was looking at the Fenix UC35 at...
Forum: General Discussion 04-07-2021, 04:43 PM
Replies: 19
Views: 197
Posted By Deerhurst
Have not heard of modlight. Should be pretty...

Have not heard of modlight. Should be pretty nutty if surefire is considered budget!
Forum: Wiring and Electrical 04-07-2021, 04:02 AM
Replies: 13
Views: 114
Posted By Deerhurst
On the D21 it is not possible to get low and high...

On the D21 it is not possible to get low and high beam filaments on at the same time (without finessing the stalk). When high beam is turned on the low beam filament is deenergized and vice versa for...
Forum: General Discussion 04-07-2021, 03:57 AM
Replies: 9
Views: 102
Posted By Deerhurst
A few on here have trucks in that good or better...

A few on here have trucks in that good or better condition with more miles or older but those are outliers. It's hard to find a good, clean little mini truck. Most have been thrashed their entire...
Forum: Hardbody Forum (D21) 04-07-2021, 02:13 AM
Replies: 18
Views: 150
Posted By Deerhurst
It'll be a Z24i. Wonder if both dizzys and coils...

It'll be a Z24i. Wonder if both dizzys and coils sets are working.
Forum: Hardbody Forum (D21) 04-07-2021, 12:10 AM
Replies: 18
Views: 150
Posted By Deerhurst
Have you pulled codes?

Have you pulled codes?
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT. The time now is 11:00 PM.

Contact Us - Infamous Nissan - Archive - Top

Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.