Going back to stock height
 

So we picked up a dropped 95 hardbody, but want to bring it back to stock height. Was looking for tutorials, but no luck. Need help/advice- thanks in advance

Welcome to IN.

Do you have any junk yards in your area? I know, HI is probably slack for this, but it's a resource many use. If so, I'd suggest you do a bit of research to see what used parts trucks are available there.

I'm sure others will chime in. GL.....

Go to RockAuto.com and look at parts and part #'s for 95 hardbody 2wd stuff. That should get you at least a decent start on "what" to get. You don't have to use RA after you get the info you need.

Well, it basically depends on exactly HOW it’s been lowered. It could just require removing the lowering blocks and adjusting the torsion bars back up. It could also need much, much more than that.