PDA

View Full Version : Mindliss Metalfab


Mindliss Metalfab
09-22-2009, 06:21 PM
Hey Guys

Thanks to the mods for allowing me as a vendor here.

Mindliss Metalfab specializes in custom laser cut parts, and also offers a wide range of standard parts (bag brackets, 4 link tabs etc)

Everything I sell is cut to order which allows me to do minor changes to any standard part at no cost. So if you need a custom length tab, different bolt hole sizes etc its not going to cost you any more than an off the shelf part would.

I also do fabricated pieces including built to spec custom control arms, frames clips and link bars. If you’ve been following the Lo Lux build in Minitruckin’ magazine, I’ve done a ton of the chassis parts for that truck.

The website will give a pretty good idea of some of the work I’ve done so I won’t bore you with details here. www.mindlissmetal.com

I will offer a 10% discount on custom parts to all Infamous Nissan members. Also make sure to check out the specials section on the website as it will change from time to time.

Thanks
http://www.mindlissmetal.com/wp-content/uploads/2009/03/bc1.png

pugz
09-22-2009, 07:12 PM
welcome to being a vendor here. ive seen alot of your work and its all top notch stuff.