How popular are civic seats?

[scrapin_frame]

I know when I had my mazda, most people went for 626 seats. I have some eg civic seats from my old b16 hatch. I swapped them for ek seats, so these have been sitting in my shed. Wondering how difficult they are to install and if they are more comfy and sit lower?

[xmb63]

I have civic seats in my hardbody but I bolted them right to the floor.

[Ratrod25]

I have pathy seats in my 720 and they were too tall.. So i cut he bracket out and just mounted them straight to the floor...

[IndecentXxXposur]

i wuz wondering the same thing cause i have some civic seats 2..and 2 driver side s10 seats...i would like to put either set in my hb..or prowler seats :)

[ScottXGTR]

if you are refering to the civic seats with the side mount headrest, they are very popular. i think ive seen them in more minis than any other type of seat. apparently they are easy to bolt in with a few mods.

http://i14.photobucket.com/albums/a307/scottxgtr/d60b_1.jpg

[david29]

At one point I had some similar Civic seats in my HB. Had to use a couple 2x2 pieces of wood on the door side of the seat to get them level. Also, could only bolt them in with 3 bolts to the factory holes.

[guhkid]

those seats are SICK....

[scrapin_frame]

if you are refering to the civic seats with the side mount headrest, they are very popular. i think ive seen them in more minis than any other type of seat. apparently they are easy to bolt in with a few mods.

http://i14.photobucket.com/albums/a307/scottxgtr/d60b_1.jpg


That would be the style I am talking about

[Scrappy]

I just did that swap this weekend. I used 2 sets of bench brackets to get mine mounted. I'll post a few pics for you this afternoon.

[fakemike]

I just did that swap this weekend. I used 2 sets of bench brackets to get mine mounted. I'll post a few pics for you this afternoon.

Did you have to modify the bench seat rails to make them fit the civic seats?

[Scrappy]

http://i41.photobucket.com/albums/e299/rollinslowandlow/0720091243a.jpg

http://i41.photobucket.com/albums/e299/rollinslowandlow/downsized_0720091243.jpg

http://i41.photobucket.com/albums/e299/rollinslowandlow/downsized_0720091244.jpg

it should be easy see what I did but ask if you have any questions.

[Scrappy]

oh and the plastic side parts screw right back on and look good.

[nis720]

I went about it alittle different.

The 89' seats were pretty straight forward. I used a flat plate to bolt the stock rails, they lined up to the factory holes.

http://carphotos.cardomain.com/ride_images/1/113/3461/281730252_large.jpg

The 93' seats required a angle plate to make the stock rails bolt on.

http://carphotos.cardomain.com/ride_images/1/113/3461/281730261_large.jpg

Kept the inner bracket and chopped off the seatbelt bolts.

http://carphotos.cardomain.com/ride_images/1/113/3461/281730265_large.jpg

[iamosolo]

I HIGHLY recommend del sol seats, especially for the tall folk. I have some in my HB. Unfortunately, I don't have any pics

[jp450r]

I HIGHLY recommend del sol seats, especially for the tall folk. I have some in my HB. Unfortunately, I don't have any picsthats what i was thinking. del sol seats sit really low. i am 6'5" and i need some low sitting seats.