aftermarket intake manifolds for the z24 motors?

[yeti_'87HB]

are there any aftermarket cold air kits and or intake manifolds for the older z24 motors, or any that can be swapped in?

[tattoos&minitrucks]

I think it is the 240Z that U can be swapped in ...there are a few guys on here that have done it... Ronnie is one ...not to put him on point but I am sure he would help out he is a cool guy....good luck

[lomofo11]

I'm not aware of any besides the side draft carb setup.

[yeti_'87HB]

i googled the 240ZX and the motor looks completely different then mine, earliest one i found was a '95, do i have to go earlier than that?

[Scrappy]

you guys are forgetting about Offenhauser they make a 4barrel intake.

Part Number is 6262-DP

it runs about $235 shipped last time I checked.

[decipher]

You can swap a 1980-83 nissan 200sx manifold same engine just round intake ports. Gives you multiport injection and a real throttle body. I have done this for my Turbo Project since i didnt want to mess with the TB injection. I have a spare Manifold Id sell if your interested.

[yeti_'87HB]

that sound sounds sic, i would prefer to have fuel injection, but i don't know if i have the time to do it right now, unless i could do it in a weekend, it would probably have to be a summer project

[yeti_'87HB]

Scrappy, does offenhauser have a website, i would be interested in a bolt on manifold

[decipher]

Here is a photo of my intake after my mods.

http://i37.tinypic.com/ab1kjq.jpg

[decipher]

You could also go for a 720 eairly truck they have carbs or on ebay and get a webber swap carb also. Im not sure but i think you could put the webber kit on a tb manifold after you remove the tb.

[Scrappy]

Offenhauser has a web site but I'm not sure if you can fine it on line.

It's been a year or so since I spoke with anyone but here is the info you need.

Riley-Auto (I think was the Company)
Contact Name: Dan
Phone Number: 559-592-2707

[ridin4life]

just googled that part number got this

jegs link
http://www.jegs.com/i/Offenhauser/750/6262-DP/10002/-1

http://www.jegs.com/images/photos/700/750/750-6209-C.jpg

this is not the manifold, i think. its the sample pic they had it woul look something like this
have a great day

[yeti_'87HB]

doesn't look like it will work, that has 5 intake ports

[Swschz]

isnt that a water gallery for the cooling or something?

[yeti_'87HB]

yes that would be it, my bad, i was drunk at like 2am lol

[yeti_'87HB]

any way of bolting on the factory z24 top mount throttle body instead of the carb, cause i know from experience that carbed engines run like a bent dick when its -30c(-22F)

[aron01]

what does swapping on the 200sx intake involve as far as the wiring? what ecm?

[quesenberry qustumz]

You could also go for a 720 eairly truck they have carbs or on ebay and get a webber swap carb also. Im not sure but i think you could put the webber kit on a tb manifold after you remove the tb.

i just did mine from tb,easy as pie...2hr job!